Installation Sheet

ManualsBrandsElkay ManualsKitchen SinksSturdibilt 97-1/2" Triple Basin Free Standing Stainless Steel Utility Sink

PAGE 1

4410BFFR_FTN_A LK4410BFFR_FTN_A

1000004253 (Rev. B - 03/20)

VALVE WATER LINE SUPPLIED

WITH A 1/4 x 1/2 NPT CONNECTOR

WATER INLET LINE

( BY INSTALLER )

DRAIN LINE BY INSTALLER

( AS REQUIRED BY LOCAL CODES )

(6) 1/2" (13mm) DIA. HOLES

EQUALLY SPACED ON A

12" ( 305mm ) BOLT CENTER

SEE DETAIL A

CONCRETE SLAB

102mm

DETAIL A

14"

356mm

29"

737mm

7 11/16"

195mm

27"

686mm

19"

483mm

27 1/8"

689mm

37 1/8"

943mm

14 9/16"

371mm

76mm

34 1/8"

867mm

57 1/8"

1451mm

10"

254mm

Owners Manual

Model 4410BFFR Tubular Bottle Filler Fountain

with Sanitary Freeze Resistant Single Valve Control Assembly

4410BFFR Fountains are among the easiest to install Fountains on the market today. To assure

you install these models easily and correctly, PLEASE READ THESE SIMPLE INSTRUCTIONS

BEFORE STARTING THE INSTALLATION. CHECK YOUR INSTALLATION FOR COMPLIANCE

WITH PLUMBING, ELECTRICAL, AND OTHER APPLICABLE CODES. After installation, leave

these instructions with the Fountain for future reference.

INSTALLER

Summary of content (11 pages)

PAGE 1
/8" 51mm 4410BFFR_FTN_A LK4410BFFR_FTN_A Owners Manual Model 4410BFFR Tubular Bottle Filler Fountain with Sanitary Freeze Resistant Single Valve Control Assembly E G C H A INSTALLER 4410BFFR Fountains are among the easiest to install Fountains on the market today. To assure you install these models easily and correctly, PLEASE READ THESE SIMPLE INSTRUCTIONS BEFORE STARTING THE INSTALLATION. CHECK YOUR INSTALLATION FOR COMPLIANCE WITH PLUMBING, ELECTRICAL, AND OTHER APPLICABLE CODES.
PAGE 2
4410BFFR_FTN_A LK4410BFFR_FTN_A INSTALLATION INSTRUCTIONS IMPORTANT ALL SERVICE TO BE PERFORMED BY AN AUTHORIZED SERVICE PERSON IMPORTANT! INSTALLER PLEASE NOTE. THE GROUNDING OF ELECTRICAL EQUIPMENT SUCH AS TELEPHONE, COMPUTERS, ETC. TO WATER LINES IS A COMMON PROCEDURE. THIS GROUNDING MAY BE IN THE BUILDING OR MAY OCCUR AWAY FROM THE BUILDING.
PAGE 3
4410BFFR_FTN_A LK4410BFFR_FTN_A SUGGESTED SITE PREPARATION DETAIL FOR THE 4410BFFR FTN. WHEN USING THE SANITARYFR1 VALVE 1-1/2" DRAIN TUBE (SUPPLIED BY INSTALLER) 4" PVC 1/4 BEND (SUPPLIED BY INSTALLER) 4" PVC PIPE (SUPPLIED BY INSTALLER) CONCRETE SLAB CLEANOUT PLUG FOR ACCESS (SUPPLIED BY INSTALLER) 4" 102mm MIN. 8 INCH INSIDE DIA. PVC PIPE, TRIM TO DESIRED LENGTH (SUPPLIED BY INSTALLER) 36" MIN. (914mm) 60"MAX. (1524mm) FROST LINE PVC 8" x 8" x 4" COMBINATION "Y" & 1/8 BEND REDUCING ASSY.
PAGE 4
410BFFR_FTN_A LK4410BFFR_FTN_A SUGGESTED SITE PREPARATION DETAIL FOR THE 4410BFFR FTN. WHEN USING THE SANITARYFR1 VALVE O 14" 356mm (6) 1/2" (13mm) DIA. HOLES EQUALLY SPACED ON A 12" ( 305mm ) BOLT CENTER 1-1/4 DRAIN TUBE SUPPLIED WITH FTN. AIR GAP ASSY.
PAGE 5
4410BFFR_FTN_A LK4410BFFR_FTN_A E G C H A FOUNTAIN CONNECTIONS PLUMBING CONDUIT (BY INSTALLER) TO VALVE FIG. 3 INSTRUCTIONS FOR CONNECTING TUBES FROM VALVE TO FOUNTAIN Step 1 - Insert the 1/8” O.D. tube (Label A) into the connector (provided with fountain). Insert the 1/8” O.D. tube coming from the fountain push button actuator into the connector. Trim any excess length. Step 2 - Secure the 1/8” O.D. tube (Label C) to the waste line assembly. This line is a vent line and should be open to the air.
PAGE 6
4410BFFR_FTN_A LK4410BFFR_FTN_A 5 6 5 4 3, 11 13 6 12 14 14 2 10 FIG. 4 1000004253 (Rev. B - 03/20) FIG.
PAGE 7
4410BFFR_FTN_A LK4410BFFR_FTN_A The Following Items are included with the SanitaryFR1 Valve PARTS LIST ITEM NO. PART NO. 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 NS 110175443890 45806C 50986C 56082C 56092C 56123C 56185C 75653C 1000003970 56218C 98678C 70817C 70828C 75639C 75652C 70683C DESCRIPTION Hex Nut - 3/8-16 Single Valve Regulator Holder Regulator Nut Poly Tubing - 1/4” (Cut To Length) - To Bubbler Poly Tubing - 1/8” (Cut To Length) - To Actuator Canister Nylon Strap - 6 ft. Air Gap Assy.
PAGE 8
4410BFFR_FTN_A LK4410BFFR_FTN_A TROUBLESHOOTING AND MAINTENANCE Insufficient Bubbler Flow: Check that the shut-off valve is wide open. Verify minimum 20 PSI supply pressure. Clean inlet strainer screen located in the valve body. Clean rubber orifice in flow control located below frost line in bushing between barb fitting and valve. No Flow: Check for leaks in the air tubing going from the push button to the valve. Make sure the air tubing compression nut is hand tight.
PAGE 9
4410BFFR_FTN_A LK4410BFFR_FTN_A INSTALLATION INSTRUCTIONS IMPORTANT ALL SERVICE TO BE PERFORMED BY AN AUTHORIZED SERVICE PERSON IMPORTANT! INSTALLER PLEASE NOTE. THE GROUNDING OF ELECTRICAL EQUIPMENT SUCH AS TELEPHONE, COMPUTERS, ETC. TO WATER LINES IS A COMMON PROCEDURE. THIS GROUNDING MAY BE IN THE BUILDING OR MAY OCCUR AWAY FROM THE BUILDING.
PAGE 10
4410BFFR_FTN_A LK4410BFFR_FTN_A 21, 22 25 16 25 28 22 52 OR 48 37 11 26 28 29 22 24 6 25 27 17 31 22 28 63 20 2 3 29 6 6 SEE NOTE 5 30 Included with Sanitary Valve 1000004253 (Rev.
PAGE 11
4410BFFR_FTN_A LK4410BFFR_FTN_A 22, 23 18 24, 24a, 24b 19 19 22, 23 16 18 22, 23 The Following Items are included with the 4410BFFR Fountain PARTS LIST ITEM NO. PART NO.