Installation Guide

ELKAY recommends that Fireclay sinks should be installed byaprofessional experienced installer.
Before installation, please inspect the sink for damage. Do not install a damaged sink.
WARNING: Due to the dimensional variation inherent in the fireclay manufacturing process, sink cutout
templates are not provided. Elkay recommends using the actual sink for the countertop cutout. It is recom-
mended that you discuss with your customer the desired finished appearance of the sink and countertop
installation. Elkay is not responsible for improper sink and/or countertop installations.
It is recommended that you discuss with your customer and agree to what the finished effect will be. Elkay
is not responsible for improper sink or countertop installations.
Elkay Fireclay undermounts must be fastened to solid surface countertops only (i.e., granite).
Elkay is not responsible for sink and countertop if damaged during installation.
Fireclay sinks are heavy, please arrange for assistance to move or position.
Follow all local plumbing and building codes.
COUNTERTOP
UNDERL
AYMENT
CABINET
SINK
1/4"
SILICONE CAULK
(NOT FURNISHED)
Elkay Fireclay Farmhouse
Undermount Sinks
CAREFULLY READ THESE INSTRUCTIONS BEFORE YOU BEGIN
ATTENTION INSTALLER
Fireclay Farmhouse Undermount Sink Only
The Elkay fireclay farmhouse sinks are reversible by design offering you two options to select. The installation
dimensions will be different depending on which farmhouse side you wish to see. The front and back walls of the
sink are not the same thickness by design. IT IS CRITICAL THAT THE CABINET MAKER, COUNTER TOP
FABRICATOR, AS WELL AS THE CABINET INSTALLER UNDERSTAND THE EXPECTATIONS OF THE
CONSUMER.
A custom sink base cabinet is required.
Proper installation requiresacoordinated effort including advanced dialog between the designer (or
customer), the cabinet maker, the countertop fabricator and the sink installer during the design and instal-
lation phase.
Elkay recommends providing the cabinet maker with the actual sink to be installed prior to cabinet fabrication.
It is required thatasupport frame be constructed inside the cabinet for adequate support of the sink as
shown in Figure 1.
Warning: The support frame and proper support for the sink must sufficiently support 300 lbs. This is the
approximate weight of the sink when full.
Templates are not included however it is recommended that the sink countertop cutout provide a reveal into
the sink bowl opening as shown in Figure 2.
Installation Instructions
FRAMING MUST
SUPPORT SINK
BOWLS
FIGURE 1
FIGURE 2

Summary of content (2 pages)