Installation Sheet

ManualsBrandsElkay ManualsCommercial PlumbingEZH20 18" Wall Mounted Single Station Hands Free Bottle Filler Combo with Cooler - Vandal Resistant Bubbler and Outdoor Approved

Page 7 98982C (Rev. H - 01/15)

VRCDWS*A, *2A VRC8WS*1A, *2A, *3A VRCTLDDWSC*A, *2A VRCTLRDDWSC*A, *2A

VRCTL8WSC*1A, *2A, *3A VRCTLR8WSC*1A, *2A, *3A

REMOVAL OF BOTTLE FILLER FOR SERVICING

1) Turn off the water supply to the Water Cooler(s). Unplug and/or turn off Circuit Breaker to Cooler(s) and Bottle Filler. NOTE: the

Lower Front Panel of the cooler(s) may need to be removed. To prevent scratching the basin place a towel or soft cloth over the

entire basin when working above it.

2) For Single Model Installations: Loosen but DO NOT remove the two (2) Pinned Torx Head Screws from the sides of the Bottle

Filler. Remove the two (2) Pinned Torx Head Screws from the Top Cover & remove the Top Cover. The Bottle Filler may then be

lifted up and off the Water Cooler (The water line and Remote Reset Button Wires will still be connected from the Water Cooler to

the Bottle Filler.).

3) For Two Level Model Installations: Loosen but DO NOT remove the Pinned Torx Head Screw from the outer side of the Bottle Filler and loosen but DO NOT remove

the 1/4” hex. head bolt from between the two cooler (See Figs 6 or 7). Remove the two (2) Pinned Torx Head Screws from the Top Cover & remove the Top Cover.

The Bottle Filler may then be lifted up and off the Water Cooler (The water line and Remote Reset Button Wires will still be connected from the Water Cooler to the

Bottle Filler.).

STANDARD TWO-LEVEL CONFIGURATION

STANDARD TWO-LEVEL REVERSED CONFIGURATION

Fig. 6

Fig. 7

1/4” HEX. HEAD BOLT THIS LOCATION ONLY