Installation Sheet

ManualsBrandsElkay ManualsDrinking FountainsElkay 18-1/16" Wall Mounted Single Drinking Station with Cooler - Vandal Resistant Bubbler and Outdoor Approved

Page 1 98661C (Rev. E - 12/17)

LVRCGRN8*1B VRCGRN8*1B

VRCGRN8™ Coolers d’Eau de Barrière-Libère de feuilleton

VRCGRN8™ La Barrera de la serie Liberta Agua Coolers

VRCGRN8™ Series Barrier-Free Water Cooler

Manual de Instalación, Cuidado y Utilización

Manuel d’installation/entretien/utilisation

INSTALLATION, CARE & USE MANUAL

Summary of content (7 pages)

PAGE 1
LVRCGRN8*1B VRCGRN8*1B INSTALLATION, CARE & USE MANUAL Manual de Instalación, Cuidado y Utilización Manuel d’installation/entretien/utilisation VRCGRN8™ Series Barrier-Free Water Cooler VRCGRN8™ La Barrera de la serie Liberta Agua Coolers VRCGRN8™ Coolers d’Eau de Barrière-Libère de feuilleton Page 1 98661C (Rev.
PAGE 2
LVRCGRN8*1B VRCGRN8*1B Note: Danger! Electric shock hazard. Disconnect power before servicing unit. Nota: peligro! Peligro de descarga eléctrica. Desconecte antes de reparar la unidad. Remarque : Danger ! Risque d'électrocution. Débrancher avant de réparer l'appareil. Uses HFC-134A refrigerant Usa refrigerante HFC-134A Utilise du fluide frigorigéne HFC-134A 10 20 6 22 9 12 36 15 15 16 1, 4 5 See Fig. 3 See Fig. 4 32 32 7, 23, 38 21 24 21 21 19 13 25 11 35 26 30 21 32 8 2 Fig.
PAGE 3
Fig. 2 Page 3 25" 635mm 21 3/8" 543mm 18 3/8" 467mm 13 7/8" 352mm E 4 9/16" 116mm B 31 7/8" 810mm RIM HEIGHT ALTURA DEL ORIFICIO HAUTEUR DE L 'ORIFICE 32 15/16" 837mm ORIFICE HEIGHT ALTURA DE LA CORONA HAUTEUR DU BORD 27" * 686mm 2 5/8" 67mm C 12 5/16" 313mm 6 1/4" 159mm 8" 203mm FINISHED FLOOR PISO ACABADO PLANCHER FINI 1 1/2" 38mm HANGER BRACKET FIJADOR DE SUSPENSION SUPPORT DE SUSPENSION ADA REQUIREMENT REQUISITO DE A.D.A.
PAGE 4
LVRCGRN8*1B IMPORTANT ALL SERVICE TO BE PERFORMED BY AN AUTHORIZED SERVICE PERSON HANGER BRACKETS & TRAP INSTALLATION 1) Remove hanger bracket fastened to back of cooler by removing one (1) screw. 2) Mount the hanger bracket and trap as shown in Figure 2. NOTE: Hanger Bracket MUST be supported securely. Add fixture support carrier if wall will not provide adequate support. IMPORTANT:  6 1/4 in. (159mm) dimension from wall to centerline of trap must be maintained for proper fit.
PAGE 5
LVRCGRN8*1B 1 Basin Estanque Bassin VRCGRN8*1B 7 1 7 1 7 Fig. 3 5 VANDAL RESISTANT BUBBLER DETAIL DETALLE DEL GRIFO RESISTENTE AL VANDALISMO DESCRIPTION DU BARBOTEUR RESISTANT AU VANDALISME 23 32 (8) 36 1 18 26 1 28 17 17 14 3 17 17 34 (4) 27 17 17 29 33 32 (6) 25 32 (2) Fig. 4 Page 5 98661C (Rev.
PAGE 6
LVRCGRN8*1B VRCGRN8*1B 32 26 31 4 Fig. 6 Fig. 5 Filter Installation Detail Detalle de la instalación del filtro Détail d’installation de filtre Glass Filler Detail Detalle de cristal del llenador Détail en verre de remplisseur 3 2 2 1 Fig. 7 WATERSENTRY® FILTER PARTS LIST (See Fig. 7) ITEM NO. PART NO. 1 2 51299C 98926C 3 1000003563 98661C (Rev.
PAGE 7
LVRCGRN8*1B VRCGRN8*1B 115V PARTS LIST/ 115V LISTA DE PIEZAS/ 115V LISTE DES PIÈCES ITEM NO. PART NO.