User guide

24
VIII ENGINEERING CHANGE REVISION EXPLANATIONS
Revision A – ECN 110616
• Table of Contents
o Added Engineering Revision Explanations section.
• Section I
o Added more detail on fiber connections under the Remote Operator Control Panel definition.
• Section III - A
o Added more detail pertaining to the jumpers in the MMCP and the problems that can occur.
• Section III – D
o When using the internal power of the panel, connect between the aux. input and terminal 51.
• Section IV
o Under Indicator Lights added explanation of the Following:
 Water valve opened and will not close.
 Foam valve opened and will not close.
Revision B – ECN 111017
• Title Page
o Added Part Number to Title
• Table of Contents
o Added Refer to Website line
• Section VI
o Added more troubleshooting symptoms and solutions.
o Added note to refer to Website before contacting Elkhart Representative
Revision C – ECN 120515
• Title Page
o Removed Part Number from Title to allow for the single monitor control panel to use the same
manual.
• Table of Contents
o Added Changing 50 / 60 Hz Monitor Operations.
o Added Adding MMCP Power On indication.
o Added explanation of the Park sequence per axis.
o Added explanation for the Monitor Auto Exercise Feature.
• Section I
o Added note explaining that this manual is written for the operation of a 2 monitor control panel
or a 1 monitor operator control panel.
o Additional note explaining the Auxiliary Device notation and it replacing Foam Valve.
• Section II
o Added note explaining the difference between a 2 monitor OCP and a 1 monitor OCP
• Section III-D
o Added explanation on keystrokes to change to 50 Hz monitor operation.
• Section III-E
o Added explanation to turn off the MMCP power on indication on the OCP.
• Section IV
o OCP Operation - Monitor physical position and position data don’t agree.
o Indicator Lights – Oscillate light continually flashing quickly.
• Section VII
Added the mounting dimension picture for the 1 monitor operator control panel