Technical data

22
2
25
28
26
1
15
18
16
15
1 6
18
25
2 6
28
SA3-02M
+
-
CIB
CIB
AC 230V
L
N
SA3-02M 8595188132374
2x switching 16 A/AC1
250 V AC1, 24 V DC
4000 VA/AC1, 384 W/DC
30 A/<3s
3.75 kV, SELV dle EN 60950
1000 V AC
100 mA
1200 min
-1
6 min
-1
3 x 10
7
0.7 x 10
5
2x yellow LED
CIB
27 V DC/50 mA, from CIB BUS
green LED RUN
max. 2.5 mm
2
/1.5 mm
2
with sleeve
-20 to +55 °C
-30 to +70 °C
IP 20 device, IP 40 mounting in the switchboard
operative control device
individual control device
1.B.E
FR-0
class 2
2.5 kV
II.
2
any
switchboard on DIN rail EN 60715
1-MODUL
90 x 18 x 65 mm
82 g
Output:
Switching voltage:
Switching load:
Surge current:
Insulation voltage between
outputs and built-in circuits:
Insulation voltage between
output relays RE1 and RE2:
Minimal switching current:
Switching frequency/no load:
Switching frequency/rated load:
Mechanical lifetime:
Electrical lifetime AC1:
Outputs indication:
Installation BUS:
Supply voltage/rated current:
Status indication unit:
Terminal:
Operating temperature:
Storing temperature:
Protection degree:
Control device purpose:
Control device constuction:
Automatic operation characteristic:
Heat and fi re resistance category:
Anti-shock category (immunity):
Rated impulse voltage:
Overvoltage category:
Pollution degree:
Operation position:
Installation:
Design:
Dimensions:
Weight:
Actuator SA3-02M is designed for switching two various appliance and loads with potentialless
contact.
SA3-02M is a switching actuator containing 2 independent relays with changeover
potentialless contacts.
Maximum load per contact is 16 A/4000 VA/AC1.
Each of the two output contacts are individually controllable and addressable.
Both relays are individually decorated input terminals, and therefore can switch various
independent potentials.
The actuator is designed for switching up to two various appliances and loads relay output
(potentialless contact).
Thanks to changeover contacts, it can be used to control one 230V power (such as blinds,
shutters or awnings) with appropriate bridging, the contacts can secure hardware blocking
the possibility of simultaneous switching of the phase on both outputs.
LEDs on the front panel signal the status of each output.
Contact status of each relay can be changed separately and manually by control buttons on
the front panel.
Switching actuators SA3 are normally supplied in the option AgSnO
2
contact material, they can
be supplied with contact AgNi by request.
SA3-02M in 1-MODULE version is designed for mounting into a switchboard, on DIN rail
EN60715.
OUTPUTS
Example of connection
TECHNICAL PARAMETERS
EAN code
Switching actuator, 2-channel SA3-02M
DIMENSIONS AND WEIGHT
CONNECTION
OPERATING CONDITIONS
POWER SUPPLY
COMMUNICATION