Technical data

23
SA3-04M
2
25
28
26
3
35
38
36
4
45
48
46
1
15
18
16
+
-
CIB
CIB
AC 230V
L
N
SA3-04M 8595188132381
4 x switching 16 A/AC1
250 V AC1, 24 V DC
4000 VA/AC1, 384 W/DC
30 A/<3s
3.75 kV, SELV by EN 60950
1000 V AC
100 mA
1200 min
-1
6 min
-1
3 x 10
7
0.7 x 10
5
4x yellow LED
CIB
27 V DC/70 mA, from CIB BUS
green LED RUN
max. 2.5 mm
2
/1.5 mm
2
with sleeve
-20 to +55 °C
-30 to +70 °C
IP 20 device, IP 40 mounting in the switchboard
operative control device
individual control device
1.B.E
FR-0
class 2
2.5 kV
II.
2
any
switchboard on DIN rail EN 60715
3-MODULE
90 x 52 x 65 mm
161 g
Output:
Switching voltage:
Switching output:
Surge current:
Insulation voltage between
outputs and internal circuits:
Insulation voltage between individual
relay outputs RE1 to RE4:
Min. switched current:
Switching frequency /no load:
Switching frequency/rated load:
Mechanical life:
Electrical life AC1:
Output indication:
Installation BUS:
Supply voltage/rated current:
Status indication unit:
Terminal:
Operating temperature:
Storing temperature:
Protection degree:
Control device purpose:
Control device constuction:
Automatic operation characteristic:
Heat and fi re resistance category:
Anti-shock category (immunity):
Rated impulse voltage:
Overvoltage category:
Pollution degree:
Operation position:
Installation:
Design:
Dimensions:
Weight:
It serves for switching of various appliances and loads with potentialless contact.
SA3-04M is a switching actuator containing 4 independent relays with changeover
potentialless contacts.
Maximum load per contact is 16 A/4000 VA/AC1.
Each of the four output contacts are individually controllable and addressable.
All four relays are individually decorated input terminals, and therefore can switch
various independent potentials.
The actuator is designed for switching to four various appliances and loads relay output
(potential free contact).
Thanks to changeover contacts, it can be used to control up to two drives 230V power
(such as blinds, shutters or awnings) with appropriate bridging, the contacts can secure
hardware blocking the possibility of simultaneous switching of the phase on both
outputs.
LEDs on the front panel signal the status of each output.
Contact status of each relay can be changed separately and manually by control
buttons on a front panel.
Switching actuators SA3 is normally supplied in the option AgSnO
2
contact material, it
can be supplied with contact AgNi by request.
SA3-04M in 3-MODULE version is designed for mounting into a switchboard, on DIN
rail EN60715.
Example of connection:
OUTPUTS
EAN code
Switching actuator, 4-channel SA3-04M
TECHNICAL PARAMETERS
DIMENSIONS AND WEIGHT
CONNECTION
OPERATING CONDITIONS
COMMUNICATION
POWER SUPPLY