Technical data

24
+
-
CIB
CIB
AC 230V
L
N
2
6
28
68
26
66
3
38
36
4
48
46
1
5
18
58
16
COM 1
COM 2
56
SA3-06M 8595188132879
58
56
68
66
Switching actuator 6-channel SA3-06M
Output:
Switching voltage:
Switching output:
Surge current:
Insulation voltage between
outputs and internal circuits:
Insulation voltage between individual
relay outputs RE1-RE4; RE5-RE6:
Min. switched current:
Switching frequency /no load:
Switching frequency/rated load:
Mechanical life:
Electrical life AC1:
Output indication:
Installation BUS:
Supply voltage/rated current:
Status indication unit:
Terminal:
Operating temperature:
Storing temperature:
Protection degree:
Control device purpose:
Control device constuction:
Automatic operation characteristic:
Heat and fi re resistance category:
Anti-shock category (immunity):
Rated impulse voltage:
Overvoltage category:
Pollution degree:
Operation position:
Installation:
Design:
Dimensions:
Weight:
The actuator is designed for switching up to six various appliances and loads with potentialless
contact.
SA3-06M is a switching actuator contains 6 independent relays with changeover potentialless
contacts.
Maximum load per contact is 8 A/2000 VA/AC1.
Each of six output contacts are individually controllable and addressable.
The relays are divided into two groups, the group of four relays on the bottom terminal
switches the common potential, a pair of relays on top of the terminal switches second
common potential.
All relays are equipped with changeover contacts, but given the common supply terminals,
four or a pair of relay, hardware does not block the ability of the current phase switching on
both outputs controlling the drive 230 V (blinds, shutters). But the actuator can control these
drives used on the prepared software blocking in IDM.
The actuator is suitable for operating discontinuously controlled thermo drives in the
distributor underfl oor heating.
LEDs on the front panel signal the status of each output.
Contact status of each relay can be changed separately and manually by control buttons on
a front panel.
SA3 is normally supplied in the option AgSnO
2
contact material, it can be supplied with contact
AgNi by request.
SA3-06M in 3-MODULE version is designed for mounting into a switchboard/DIN rail EN60715.
DIMENSIONS AND WEIGHT
Example of connection
CONNECTION
OPERATING CONDITIONS
OUTPUTS
COMMUNICATION
POWER SUPPLY
EAN code
TECHNICAL PARAMETERS
6 x switching 8 A/AC1
250 V AC1, 24 V DC
2000 VA/AC1, 192 W/DC
20 A/<3s
3.75 kV, SELV by EN 60950
1000 V AC
10 mA/ 10V
300 min
-1
15 min
-1
1 x 10
7
1 x 10
5
6x yellow LED
CIB
27 V DC/60 mA, from CIB BUS
green LED RUN
max. 2.5 mm
2
/1.5 mm
2
with sleeve
-20 to +55 °C
-30 to +70 °C
IP20 device, IP40 mounting in the switchboard
operative control device
individual control device
1.B.E
FR-0
class 2
2.5 kV
II.
2
any
switchboard on DIN rail EN 60715
3-MODULE
90 x 52 x 65 mm
256 g