Technical data
28
DA3-22M
CIB +
CIB -
AC 230 V
DA3-22M 8595188132626
L
N
F 5A
Universal dimming actuator, 2-channel DA3-22M
type of source symbol description
R
resistive
ordinary light bulb, halogen lamp
L
inductive
coiled transformer for low-voltage halogen lamps
C
capacitive
electronic transformer for low-voltage halogen lamps
LED
LED lamps and LED light sources, 230 V
ESL
dimmable energy-saving uorescent tubes
2x inputs, switching potential L
YES, input for external thermo sensor TC/TZ
+15 to +35°C; 0.3°C from the range
2x buttons,
4x potenciometers on front panel
2 contactless outputs, 2x MOSFET
resistive, inductive, capacitive*, LED, ESL
YES
3.75 kV, SELV according to EN 60950
max. 500 V AC
10 VA
400 VA for each channel
2x yellow LED
- thermal
- short-term overload
- long-term overload
CIB
27 V DC/10 mA, from CIB BUS
green LED RUN
max. 2.5 mm
2
/1.5 mm
2
with sleeve
-20 to +35 °C
-30 to +70 °C
IP 20 device, IP 40 mounting in the switchboard
FR-0
class 2
2.5 kV
II.
2
vertical
switchboard on DIN rail EN 60715
3-MODULE
90 x 52 x 65 mm
136 g
DA3-22M is a universal dimming two-channel actuator used to control light intensity
of dimmable energy saving lamps (ESL), LED bulbs and R, L, C with power suppl 230 V
AC, but you can also use the actuator for switching appliances.
DA3-22M integrates 2 binary inputs, which allow 230V AC voltage connection (normal
wall switch contacts) These inputs are in taken in the software IDM as standard binary
inputs.
DA3-22M has two MOSFET controlled outputs 230V AC, maximum load is 2x 400 VA.
Type of light source is set by a switch on the front panel.
By setting the min. brightness potentiometer on the front panel, fl ashing is eliminated
of diff erent types of light sources.
Buttons on the front panel, you can manually switch on or off the corresponding
output.
Electronic overcurrent and thermal protection - switch off output in case of overload
short circuit and overheating.
During installation, it is necessary to leave on each side of the actuator at least half the
module space for better cooling.
DA3-22M in 3-MODULE version is designed for mounting into a switchboard on DIN
rail EN60715.
Input:
Temperature measuring:
Scope and accuracy of temp. measurement:
Number of control buttons:
Output:
Load type:
Galvanic separation:
Insulation voltage between outputs
and built-in circuits:
Isolation voltage between particular
power:
Minimal controlled load:
Maximal controlled load:
Output indication ON/OFF:
Device protection:
Installation BUS:
Supply voltage/rated current:
Status indication unit:
Terminal:
Operating temperature:
Storing temperature:
Protection degree:
Heat and fi re resistance category:
Anti-shock category (immunity):
Rated impulse voltage:
Overvoltage category:
Pollution degree:
Operating position:
Installation:
Design:
Dimensions:
Weight:
INPUTS
Types of connectable loads:
TECHNICAL PARAMETERS
A list of dimmable light sources can be found here: http://www.elkoep.com/solutions
temperature sensor TC / TZ
*Attention: It is not allowed to connect loads of inductive and capacitive character,
at the same time.
DIMENSIONS AND WEIGHT
CONNECTION
OPERATING CONDITIONS
POWER SUPPLY
COMMUNICATION
OUTPUTS
EAN code
Example of connection