Technical data
47
WMR3-11
CIB
CIB
+
-
8–14 V AC/DC
WMR3-11 8595188132756
electric door lock
2
RFID 125 kHz ± 6 kHz
ISO Card Unique
Unique 64 Bits RF/64 ASK Manchester,
compatible with EM4100
1x changeover 8A / AgSnO
2
red, green LED
piezo-changer
230V AC/ 30V DC
2000 VA/AC1; 240 W/DC
20 A/<3s
3.75 kV, SELV according to EN 60950
10 mA / 10 V
300 min
-1
15 min
-1
1 x 10
7
1 x 10
5
CIB BUS
27 V DC/50 mA, from CIB
terminals, 0.5 - 1 mm
2
max. 2.5 mm
2
/1.5 mm
2
with sleeve
-20 to +55 °C
-30 to +70 °C
IP20
II.
2
any
into installation box
85.6 x 85.6 x 30 mm
94 x 94 x 30 mm
82 g (without frame)
Number of control buttons:
Type:
Supported cards:
IC Type:
Output:
Indication:
Acustic output:
Switching voltage:
Switching output:
Peak current:
Insulation voltage between relay
outputs and internal circuits:
Minimal switched current:
Switching frequency without load:
Switching frequency with rated load:
Mechanical life:
Electrical life AC1:
Installation BUS:
Supply voltage/rated current:
Data:
Network:
Operating temperature:
Storing temperature:
Protection degree:
Overvoltage category:
Pollution degree:
Operation position:
Installation:
Dimensions (plastic):
Dimensions (metal, glass, wood, granite):
Weight:
POWER SUPPLYÍ
CARD READER
CONNECTION
OUTPUTS
COMMUNICATION
INPUTS
DIMENSIONS AND WEIGHT
TECHNICAL PARAMETERS
Example of connection
EAN code
Wall card reader WMR3-11
WMR3-11 is a wall-mounted card reader that is designed for read contactless media
(smart cards, key chains, etc.).
It can be used for security system controlling (locking/unlocking), as a access system
(doors, gates, etc.) and also as a control of appliances operating (due to the designed
permitions).
WMR3-11 supports RFID media with frequence 125 kHz and with IC type Unique 64 bits
Ask Manchester.
It contains two buttons (UP/DOWN) with same functions as WSB3-20.
Indication two-color LED in the controller cover can indicate not only the status of
controlled appliance, but also the status of any sensor or actuator in the system.
WMR3-11 is also equipped with 8A relay output with changeover contact AgSnO
2
, by
which controlled devices can be switched directly (or any actuator in the system can
be set in software IDM).
WMR3-11 in LOGUS90 design is intended for mounting into wiring box.