Full Product Manual

Protecting the Bath

Cover and protect the bath shell and xtures from scratches or other damages during the

installation and tests. Remove the access panels when moving the Walk in Bath and always

lift the bathtub from the frame (Page #2).

Water Test

Fill tub for a minimum of 20 minutes to test that the pumps are functioning properly before

nal in-wall installation to avoid unnecessary repairs or removal.

Electrical

Pump: 120 VAC, 10 AMPS, 60 HZ, GFCI protected circuits

Heater: 120 V, Back: 47.4W, Seat: 44.6W, Total: 92W

DO NOT use any kind of extension cords to power the unit.

Operating the pump without rst lling the bath to above the jets can cause permanent

damage to your equipment.

Before Installation