Use and Care Manual
www.ellasbubbles.com
Installing the Faucet System
To install the faucet set, begin by using masking tape on the fiberglass surface over the area
to be marked-off and drilled.
Mark the posion of the holes for the faucets / taps onto the taped off area. Be sure that
your piping will not be obstructed by the Walk in Bath stainless steel framework or any other
obstacle.
Remember: Measure twice and cut once.
To cut the holes use a coring bit. Using the tape to help with a clean cut, drill through the
surface.
Connect the hot and cold water supply lines with a 3/4” water heater type flex hose adapter
with a female connector.
Cauon: Be sure the flex hose has rubber washers on both ends.
In a case where the plumbing is not on the same side as it is on your Ella Walk in Bath, the
plumbing may be run underneath your bathtub.
8