Toll Free 1-800-480-6850 Narrow • Short • Small • Front Entry • Deep Bariatric • Low-Threshold • Lay-Down • Wheelchair High quality luxury offering safety and independent living.
Table of Contents Table of Contents ........................................................................................1 IMPORTANT Safety Instructions..................................................................2 Unpacking your Walk in Bath.......................................................................3 Preparing for Installation............................................................................4 Installation - leveling the Bathtub..................................................
Important Safety Instructions WARNING: ***Read through the entire manual completely before begining installation.*** Use only licenced plumbers and electricians for installation. Be sure you and your contractor are aware of and follow all local plumbing and electrical codes. Your Ella Walk in Bath is not intended for outdoor use. Install the tub in accordance with the instructions in the manual. Use ONLY the parts and accessories provided or as recomended by the manufacturer.
Unpacking your Walk in Bath 1. While Unpacking your new Walk in Bath inspect the product and packing thoroughly for freight damages. If there are any noticeable damages **DO NOT ACCEPT the unit from the carrier** and call us as soon as possible at: 800-480-6850 2. Upon receiving your Ella Walk In Tub, please open immediately and check for any damages. Damages due to delivery MUST be reported to Ella within 48 hours of receipt.
Preparing for Installation Remove access panels that are held on by magnets. Remove these by using the orange suction cups on the panel and put them in a safe place until installation is complete. Orange Suction Cup Front Panel Place all accessories to the side. Make sure no loose parts are hanging. Lift and carry the bath only by the deck or frame. Protect the bottom of the bath to avoid breaking the jets at the bottom. Only accessories approved by Ella Walk in Bath should be used with this product.
Installation -Leveling the Walk in Bath Remove the existing tub and the wall and floor materials as required. Clean area of any debris or trash. Use 5 foot level and determine if the floor is level. If the floor is not level adjust all leveling feet to perfectly level the tub. Make sure you level the walk in tub from the highest elevation point on the floor.
Plumbing Installation Dry fit the plumbing before final assembly to make sure that the pipe lengths are correct and there is proper clearance throughout. Assemble kit as shown. Check your local plumbing codes to insure the proper fixatives (glue) are used. Tighten down the nuts. Install Overflow elbow with gasket. Secure to the tub with retaining plate and nut. Install cover plate and secure with set screw. Install a pipesection so that the door drain tube is located on the horizontal center line.
Installing the Faucet System To install the faucet set, begin by using masking tape on the fiberglass surface over the area to be marked-off and drilled. Mark the position of the holes for the faucets / taps onto the taped off area. Be sure that your piping will not be obstructed by the Walk in Bath stainless steel framework or any other obstacle. Remember: Measure twice and cut once. To cut the holes use a coring bit. Using the tape to help with a clean cut, drill through the surface.
Faucet Options Ella Gel Coat Walk in Baths come with one of two types of faucets. 1. One Piece Chrome Finish Brass Faucet * Installed on models: Front Entry and Small Walk In Baths 2.
Huntington Brass 5 Piece Roman Faucet www.ellasbubbles.
Huntington Brass 5 Piece Roman Faucet www.ellasbubbles.
Huntington Brass 5 Piece Roman Faucet www.ellasbubbles.
Electrical Installation Requirements Installation of electrical components must be done by a licenced electrician. IMPORTANT: All units need a NEMA plug to be plugged into a GCFI outlet that is connected to a separate circuit with a 20 amp. breaker run directly from breaker panel box. **WARNING** If the GCFI fails to operate, there is ground current flowing, indicating the possibility of electrical shock. Do not use your Walk in Bath until a repairman has addressed the fault.
Air Massage System 18 Air Jet System FEATURES: - 3 Speed air switch: high, medium and low. - 20 Minute timer. - 500 Watt Air Blower Motor. - 300 Watt Ceramic Air Heater. - 1 Minute purge cycle 20 minutes after the system has been turned off. - Specially designed for a quieter performance. - All models are equipped with high quality exclusive long life brushes. - Integrated thermal protection - Heater Thermostat. - CSA, CSA-US, UL KETI and AS/NZS certified. www.ellasbubbles.
Hydro Massage System Hydro pump comes with either an In-Line water heater or an Aquaheat Jacket system. 6 Hydro Jet System Pump with Aquaheat jacket on www.ellasbubbles.
Final Inspections After both the electrical and plumbing installation are done, a final inspection of these parts needs to be completed before finishing the installation. Close the drain and fill the walk in tub until it is up to a normal water height level which is 1” to 2” below the overflow and drain lever. Overflow and Drain lever CLOSED OPEN Allow the water to stand in walk in tub for 30 minutes and then inspect all plumbing and seals for leaks. If there are any leaks or concerns call 1-800-480-6850.
Final Inspections ...continued. Before filling your Ella Walk in Bath with water, be sure to wipe down the door seal and the surrounding surface of the door jam. Use a damp washcloth to remove any debris, construction dust and oils that may prevent the seal from working properly. Fill your Ella Walk in Bath with water. After at least 5 minutes check the installation for leaks along the door seam and plumbing connections. If applicable, Turn on the pump and or blower, let it run for at least 5 minutes.
Operation Instructions 1. Entering Your Ella Walk in Bath Enter your Walk in Bath then close and seal the door by pulling the handle toward you, into the locked position. WARNING: The Walk in Bath door handle is put together with the strongest materials available, though it will not withstand a person putting their whole weight against it while either trying to pull themselves up out of the bath or using excessive force closing the door.
Operation Instructions ...Continued 5. Huntington Brass 5 Piece Roman Faucet The ADA compliant 5 piece system is equipped with individual handles for Hot and cold water and a stand alone diverter for the included hand shower. Hand-Held Showerhead Hot & Cold Water Valve Roman Water Spout Shower / Bath Diverter 6. Using the Pumps The water level in your Walk in Bath must be approximately 2” above the jets before the Air or Hydro systems should be turned on to avoid possible damage to the pumps.
Operation Instructions ...Continued 7. Hydro Massage System, Using the Touch Sensor. Fill water up over the chrome sensor near the walk in tub seat. To activate the switch a person is required to be sitting in the water otherwise the Hydrotherapy jets will not turn on.
Operation Instructions ...Continued 8. Air Massage System Air Massage 3 Speed Control. Step 1 : Button is located on the same side as the walk in tub door handle. Step 2 : To operate press the air button. - Press button “Once” for LOW speed - Press button “Twice” for MEDIUM speed - Press button “Three times” for HIGH speed - Press button “Four times” to turn OFF Next to the Air button, a circular dial lets you change the volume of air being introduced into the Hydro massage system.
Cleaning and Maintenance Regular care of your Ella Walk in Bath will keep it clean and have it working at its best for many years to come. DO NOT under any circumstances use wire brushes, metal sponges, steel wool, or scouring pads on any part of your Ella Walk in Bath. DO NOT under any circumstances use powerful solvents such as acetone, lacquer, paint thinner, benzene or abrasive cleaner on any part of your Ella Walk in Bath.
Frequently Asked Questions Q. “The door seal isn’t completely compressed. Should I try adjusting the door to make it tighter? A. NO, there is no need to. Never adjust, move, undo or tamper with the door hinge. In some cases the door seal needs to reform its shape. This can easily be done by allowing the door to stay open when not in use. Q. ”How often should I clean my Ella Walk in Bath?” A. Wipe your tub off after each use. It is important to wipe your door seal and remove any debris. Q.
Ella Gel Coat Walk In Bath Warranty Information Unit manufactured of fiberglass reinforced polyester resin, that it will, free of charge, repair any Ella’s unit found to be defective in material or workmanship upon inspection by an authorized representative of Ella’s for a period of thirty (30) years from the date of purchase of the unit by a qualified professional.
www.ellasbubbles.
Warranty Activation Form 1 of 2 Model: _______________________ Serial Number: ____________________ Purchase Date:_______________ Purchase price:____________________ Place of Purchase:_____________________________________________________________ Contact Name:______________________ Phone Number:_____________________ Upon completing the installation of an Ella Walk In Bath, the following Warranty Activation Form must be completed, signed by both the customer and installer, and returned to Ella’s Bubble
Warranty Activation Form 2 of 2 OWNER’S INFORMATION: _____________________________________________________________________________ Name _____________________________________________________________________________ Address City State ZIP ____________________________ Telephone _________________________________________ E-mail ___________________________ Date _________________________________________ Signature INSTALLER’S INFORMATION: _______________________________________________________________________