Use and Care Manual
www.ellasbubbles.com
Plumbing Installaon
Dry fit the plumbing before final assembly to make sure that the pipe lengths are correct
and there is proper clearance throughout.
Assemble kit as shown. Check your local plumbing codes to insure the proper fixaves
(glue) are used.
Tighten down the nuts.
Install Overflow elbow with gasket. Secure to the tub with retaining plate and nut. Install
cover plate and secure with set screw.
Install a pipesecon so that the door drain tube is located on the horizontal center line.
Install the waste elbow with actuator gasket. Secure to the bath with strainer plate and nut.
Cauon:
Be sure to adjust the stopper height to allow for propper drain operaon. Test for proper
drain funcon before connuing.
Once the drain is effecvely draining at the desired height, ghten the screw on top of the
strainer to secure drain cap height.
Check all connecons and ghten down any loose fings, set crews, ...etc.
6