Use and Care Manual

1. To install the faucet set, begin by using masking tape on the berglass surface over the

are to be marked-off and drilled.

2. Mark the position of the holes for the faucets/ taps onto the taped off area. Be sure that

your piping will not be obstructed by the Walk In Tub stainless steel framework or any

other obstacle.

REMEMBER: Measure twice and cut once.

3. To cut the holes use a coring bit. Using the tape to help with a clean cut, drill through the

surface.

4. Connect the hot and cold water supply lines with a 3/4" water heater type ex hose

adapter with a female connector.

CAUTION: Be sure the ex hose has rubber washers on both ends.

In a case where the plumbing is not on the same side as it is on your Ella Walk In Tub, the

plumbing may be run underneath your bathtub.

Installing the Faucet System