Use and Care Manual

Remove access panels that are held on by magnets. Remove these by using the yellow

suction cups on the panel and put them in a safe place until installation is complete.

Place all accessories to the side. Make sure no loose parts are hanging. Lift and carry the

bath only by the deck or frame. Protect the bottom of the bath to avoid breaking the jets at

the bottom. Only accessories approved by Ella Walk In Tub should be used with this product.

All Ella Walk In Tubs are tested and operated in our factory prior to shipment. Transportation

and/or mishandling may cause leaks. Testing the Walk In Tub while you have access to all

sides is imperative! ONLY after all of the water and electrical testing is completed, and all

xtures have been checked, the tub should be installed to the surrounded wall or walls.

Place the Walk In Tub on a at surface where the water can be drained.

With a clean rag, clean the door seal on your Walk In Tub to remove any debris left from the

manufacturing process.

Preparing for Installation