Ella Gel Coat Walk In Tub OWNER'S MANUAL REPRESENTING THESE MODEL NUMBERS: Small 45″ Long 264501L / 264501R 264502L / 264502R 264503L / 264503R 264504L / 264504R Short 45″ Long 284801L / 284801R 284802L / 284802R 284803L / 284803R 284804L / 284804R Long 326001L / 326001R 326002L / 326002R 326003L / 326003R 326004L / 326004R Low 3.
Contents Important Safety Instructions............................................................................................................. 1 Unpack and Inspect........................................................................................................................... 2 Preparing for Installation.................................................................................................................... 3 Installation of Bath....................................................
Important Safety Instructions WARNING: ***Read through the entire manual completely before beginning installation.*** Contract a licensed plumber and electrician for installation. Be sure you and your contractor are aware and follow all local plumbing and electrical codes. Your Ella Walk In Tub is not intended for outdoor use. Install the tub in accordance with the instructions in the manual. Use ONLY the parts and accessories provided or as recommended by the manufacturer.
Unpack and Inspect 1. While unpacking your new Walk In Tub inspect the product and packing thoroughly for freight damages. If there are any noticeable damages ***DO NOT ACCEPT the unit from the carrier*** and call us as soon as possible at: 1-800-480-6850 2. Upon receiving your Ella Walk In Tub, please open immediately and check for any damages. Damages due to delivery MUST be reported to Ella within 48 hours of receipt.
Preparing for Installation Remove access panels that are held on by magnets. Remove these by using the yellow suction cups on the panel and put them in a safe place until installation is complete. Place all accessories to the side. Make sure no loose parts are hanging. Lift and carry the bath only by the deck or frame. Protect the bottom of the bath to avoid breaking the jets at the bottom. Only accessories approved by Ella Walk In Tub should be used with this product.
Installation of Bath 1. Remove the existing tub and the wall and floor materials as required. 2. Clean area of any debris or trash. 3. Use 4 foot level and determine if the floor is level. If the floor is not level adjust all leveling feet to perfectly level the tub. 4. Make sure you level the Walk In Tub from the highest elevation point on the floor. Feet on the Walk In Tub need to be leveled 5.
Plumbing Installation 1. Dry fit the plumbing before final assembly to make sure that the pipe lengths are correct and there is proper clearance throughout. 2. Assemble kit as show. Check your local plumbing codes to insure that proper fixatives (glue) are used. 3. Tighten down the nuts. 4. Install Overflow elbow with gasket. Secure to the tub with retaining plate and nut. Install cover plate and secure with set screw. 5.
Over-flow Plumbing Diagram Waste & Overflow Assembly Instructions 792ws Overflow Gasket D50-10 Overflow Plate D50-11 Overflow Nut D50-1 Overflow Plate D50-12H Lever For Handle D50FH-1 Flex Head Assembly Less Cable Sch 40 PVC Fittings Solid Brass Finished Trim Adjustable Head Angle Lever Handle for Overflow D50-2T Stopper D50-5W Stopper Washer D50FH-4 Socket Nut D50FH-3 Socket Washer D50-4 Stopper Adjustment Screw D50-45 45”Cable D50FH-2 FLex Head Socket D50-3 Stopper Lock Nut D50-6 Strainer Reta
Installing the Faucet System 1. To install the faucet set, begin by using masking tape on the fiberglass surface over the are to be marked-off and drilled. 2. Mark the position of the holes for the faucets/ taps onto the taped off area. Be sure that your piping will not be obstructed by the Walk In Tub stainless steel framework or any other obstacle. REMEMBER: Measure twice and cut once. 3. To cut the holes use a coring bit. Using the tape to help with a clean cut, drill through the surface. 4.
Faucet Options Ella Gel Coat Walk In Tubs comes with one of two types of faucets. 1. One Piece Chrome Finish Brass Faucet Front Entry and Small 45" Long Walk In Tubs 2. Huntington Brass 5 Piece Roman Faucet Narrow-Short-Deep-Bariatric-Low-Lay Down-Wheelchair-Long One Piece Chrome Finish Brass Faucet (comes installed only if requested) Front Entry, Small • • • • 7.
www.ellasbubbles.com Page 9 Thank you for using Huntington Brass products Allen Wrench Groove joint plier Silicone Caulking CO NE SI LI Pipe Tape Adjustable Wrench Tools You Will Need Hot Hot Cold Cold Spout Hot Hand show er Cold Cold First make sure that the bottom lock nut and washer are installed on to the valve. Next, from underneath the deck surface slide valve hot side valve assembly up through left hole in counter. Next screw the handle base flange onto the top of the valve.
Huntington Brass 5 Piece Roman Faucet SPECIFICATION / BREAK DOWN 5pc Roman Tub Filler HB9937P Description t 8” - 16” Roman Tub Filler t Solid brass spout t ceramic EJTD DBrtridges t Quick connect spout installation t NPS connections t (P. BWFSBHF ! 14* Standards t ASME A112.18.1 $ompliant t Listed *"1.0 / 61$ & cUP$ t "%" Accessibility (VJEFMJOFs for Buildings and Facilities - 4.27.
Huntington Brass 5 Piece Roman Faucet SPECIFIED MODEL 1" 9_ 2 1" 7_ 8 7" 7_ 8 1" 2_ 2 1" 8_ 2 7" 5_ 8 1" 4_ 4 3" 2_ 4 1_ " connection 2 3" 2_ 8 1 Max ~ 1 _ 2 3 _ " NPS 4 Tub 4"- 8"(Ref) 1_ " MAX~1 2 (Ref ) 8"- 16"(Ref) www.ellasbubbles.
Electrical Installation Requirements Installation of electrical components must be done by a licensed electrician. Important: All units need a NEMA plug to be plugged into a GFCI outlet that is connected to a separate circuit with a 20AMP breaker run directly from breaker panel box. ***WARNING*** If the GFCI fails to operate, there is ground current flowing, indicating the possibility of electrical shock. Do not use your Walk In Tub until a repairman has addressed the fault.
Air Massage System 18 Air Jet System FEATURES: • 3 Speed air switch: high, medium and low. • 20 Minute timer. • 500 Watt Air Blower Motor • 300 Watt Ceramic Air Heater • 1 Minute purge cycle 20 minutes after the system has been turned off • Specially designed for a quieter performance • All models are equipped with high quality exclusive long life brushes. • Integrated thermal protection • Heater Thermostat • CSA, CSA-US.
Hydro Massage System Hydro pump comes with an In-Line water heater. 6 Hydro Jet System IN-LINE HEATER 15 AMP 120 VOLT GFCI PROTECTED MAIN CIRCUIT GROUND 20 AMP 120 VOLT GFCI PROTECTED PUMP CONTROL (GREEN) GROUND (WHITE) NEUTRAL OUTPUT POWER CABLE (BLACK) HOT INPUT POWER CABLE JUNCTION BOX www.ellasbubbles.
Final Inspections After both the electrical and plumbing installation are done, a final inspection of these parts needs to be completed before finishing the installation. Close the drain and fill the Walk In Tub until it is up to a normal water height level which is 1" to 2" below the overflow and drain lever. Overflow and Drain Lever CLOSED OPEN Allow the water to stand in Walk In Tub for 30 minutes and then inspect all plumbing and seals for leaks.
Finishing Installation An extension Panel is used to extend the length of your Ella Walk In Tub to a 60" length. Some installations require trimming the extension Panel. Cutting the extension pieces should be done with a reciprocation saw; a progressive blade is best or a bi-metal blade will work as well. Measure the distance between the wall and the Walk In Tub by the three corners and at the middle of each length so as to detect any variance in the shape of the wall.
Operation Instructions 1. Entering Your Ella Walk In Tub Enter your Walk In Tub then close and seal the door by pulling the handle toward you, into the locked position. WARNING: The Walk In Tub door handle is put together with the strongest materials available, though it will not withstand a person putting their entire weight against it while either trying to pull themselves up out of the bath of using excessive force closing the door.
Operating Instructions Continued 5. Huntington Brass 5 Piece Roman Faucet The ADA compliant 5 piece system is equipped with individual handles for hot and cold water and a stand alone diverter for the included hand shower. Hand Held Shower Head Hot & Cold Water Valve Roman Water Spout Shower/Bath Diverter 6. Using the Pumps The water level in your Walk In Tub must be appropriately 2" above the jets before the Air or Hydro systems should be turned on to avoid possible damage to the pumps.
Operating Instructions Continued 7. Air Massage System Air Massage 3 Speed Control. Step 1: Button is located on the same side as the Walk In Tub door handle. Step 2: T o operate press the air button. Press button “Once” for LOW speed Press button “Twice” for MEDIUM speed Press button “Three Times” for HIGH speed Press button “Four Times” to turn OFF Next to the Air button, a circular dial lets you change the volume of air being introduced into the Hydro massage system.
Cleaning and Maintenance Regular care of your Ella Walk In Tub will keep it clean and have it working at its best for many years to come. The best way to counteract from detrimental affects occurring is to prevent water from remaining on any finished surface on the Walk In Tub. Wipe down your Walk In Tub after every use! DO NOT under any circumstances use wire brushes, metal sponges, steel wool, or scouring pads on any part of your Ella Walk In Tub.
Frequently Asked Questions Q: “The door seal isn’t completely compressed. Should I try adjusting the door to make it tighter? A: NO, there is no need to. Never adjust, move, undo or tamper with the door hinge. In some cases the door seal needs to reform its shape. This can easily be done by allowing the door to stay open when not in use. Q: “How often should I clean my Ella Walk In Tub?” A: Wipe your tub off after each use. It is important to wipe your door seal and remove any debris.
May 2013 TOLL FREE: 800-480-6850
Warranty Activation Form 1 of 2 INSTALLER'S INFORMATION ________________________________________________________________________________________ Name ________________________________________________________________________________________ Address City State Zip __________________________________ Telephone __________________________________________________ Email __________________________________ Date __________________________________________________ Signature Upon completing the installation of an
Warranty Activation Form 2 of 2 OWNER'S INFORMATION ________________________________________________________________________________________ Name ________________________________________________________________________________________ Address City State Zip __________________________________ Telephone __________________________________________________ Email __________________________________ Date __________________________________________________ Signature Model: ____________________________________