Use and Care Manual

1. Dry t the plumbing before nal assembly to make sure that the pipe lengths are correct

and there is proper clearance throughout.

2. Assemble kit as show. Check your local plumbing codes to insure that proper xatives

(glue) are used.

3. Tighten down the nuts.

4. Install Overow elbow with gasket. Secure to the tub with retaining plate and nut. Install

cover plate and secure with set screw.

5. Install a pipe section so that the door drain tube is located on the horizontal center line.

6. Install the waste elbow with actuator gasket. Secure to the bath with strainer plate and

nut.

CAUTION:

Be sure to adjust the stopper height to allow proper drain function. Test for proper drain

function before continuing.

7. Once the drain is effectively draining at the desired height, tighten the screw on top of

the strainer to secure drain cap height.

8. Check all connections and tighten down any loose ttings, set screws, etc.

Plumbing Installation