Installation Guide

Required Steps Prior to Installation

www.ellasbubbles.com Page 10 03/18

Place the tub on a completely flat surface in an area where it may be drained after

testing.

Using a clean rag and warm water wipe down seal to insure it is free of debris.

Seal the drains (this can be done with tape) and fill the tub to at least three inches

above the highest jet, or to the bottom of the grab bar if no jets are present.

Allow the water to stand in tub for 30 minutes and then inspect all plumbing and seals for

leaks.

Using appropriately rated three-prong extension cords, all plugged in to separate outlets,

operate all electrical components (air blower, water pump, and heater if applicable) for

another 30 minutes and inspect for leaks again. Inspect the unions around the pump and

heater.

If a leak persists at a union after tightening, it may have been over-tightened or might

have a displaced O-ring. Disassemble it and make sure the O-ring was seated properly.

Do the same if a leak persists at the heater. Verify that the heater threads match the

pipe threads.

Protecting the Bath

Cover and protect the bath shell and fixtures from scratches or other damages during the

installation and tests. Remove the access panels when moving the Walk in Bath and

always lift the bathtub from the frame.

Electrical

The unit MUST be connected to a circuit protected by a ground fault circuit interrupter

(GFCI) provided and installed by a licensed electrician and tested periodically (refer to

instructions provided by GFCI manufacturer). Electrical requirements vary based on

package; please refer to package diagrams included in the specifications. A licensed

electrician for your area is required to install and test the electrical installation process. DO

NOT use any kind of extension cords to power the unit.

Operating the pumps without first filling the bath to above the jets can cause permanent

damage to your equipment.

Push the GFCI “test” button into “reset” mode. If the GFCI fails to operate in this manner,

there is a ground current flow or a device malfunction, indicating the possibility of electrical

shock. If this occurs, turn OFF the power and do not use the bathtub until the source of the

problem has been identified and corrected.

Water Test

It is important to test that the Hydro and Air Pumps are functioning properly before final in-

wall installation to avoid unnecessary repairs or removal.