Installation Guide

Page 6
System Identification: CIMC
-296-01-[01 or 02]-01 Configuration #1
System features: Air Buttons or Electronic Keypad, Independent Timers, Single Conductive Water Detect.
Note: For instructions on setting the Configuration # see
“Control Configuration Selection and Setting Guide
Installation Diagram:
Air Button Option
TO PUMP
Max 15 AMPS Load
NOTES:
1.
PUMPS equipped with air switch must be in the
“ON” position prior to plugging into the controller.
2.
The combined rating of both Loads must not exceed the Controller
’s Amperage Rating.
3.
Connect cables to ports as shown. Installation may not require the use of all connection ports.
Failure to connect cables to ports as shown, may damage the control box and its components.
Air
Light
Water
Female
Cord
Plug
located
on TOP
Page 7
TOUCHSTONE Dual Load Control System
Installation Instructions
01 Configuration #1
Air Buttons or Electronic Keypad, Independent Timers, Single
-
Speed Pump, Variable
-Speed Blower, Multi-Color LED Tub Lights,
Control Configuration Selection and Setting Guide
”
Male Cord
position prior to plugging into the controller.
s Amperage Rating.
Connect cables to ports as shown. Installation may not require the use of all connection ports.
Failure to connect cables to ports as shown, may damage the control box and its components.
CCBL-366
x2 daisy
chained
or
CCBL-376
“Y” Splitter
Electronic Keypad Option
CICL-297
Tub Lights
x2 Max.
To 120V GFCI
Protected
Receptacle
15A or 20A
According To
The Controller
Model
Female
Cord
Plugs
located
on
REAR
TO BLOWER
Max 8 AMPS Load
CCBL-372
CCBL-143
Conductive Water
Detect