Installation Guide

Warranty Activation Form 1 of 2

INSTALLER'S INFORMATION

_______________________________________________________________________________________

Name

_______________________________________________________________________________________

Address City State Zip

_________________________________ _________________________________________________

Telephone Email

_________________________________ _________________________________________________

Date Signature

Upon completing the installation of an Ella Walk In Bath, the following Warranty

Activation Form must be completed, signed by both the customer and installer, and

returned to Ella’s Bubbles, LLC. In order for the Warranty to be activated (faxed, scanned,

or emailed, or hard copy mailed).

To be initialed by the installer(s)

____Tub is level in all directions and all support legs are touching the ground.

____Tub is installed on a dedicated 30 Amp GFCI protected circuit using 10 gauge wire

____Frame of the tub has been properly grounded.

____ Door Seal has been cleaned with rubbing alcohol to remove any dust or debris left

over from construction.

____Temperature Control Valve operated on both hot and cold settings.

____Both diverters function properly.

____Hand Shower functions on all settings without leaking.

____All supply lines have been checked for leaks while both diverters are on.

____ Drains open and close properly, and the locking nut has been tightened on both

stoppers.

____Door seal is water tight after tub has been lled for a minimum of 20 minutes.

____ After running for a minimum of 20 Minutes both the Hydro and Air Pumps are

functioning properly and all connections to the pumps and jets are water tight.

____ Chromatherapy Light and the Ozone Sterilization are working properly. (When the

Ozone is on by itself it will make a light humming noise).

____All drain ttings have been checked for leaks while the tub is draining.

____Unit is installed with access to both plumbing and electrical connections.