Installation Guide

ALWAYS INSTALL SPOUT BEFORE THE WALK IN BATH IS IN PLACE.

Parts List: Rubber gasket x (1)

Rubber washer x (1)

Brass mounting nut x (1)

To Install the supplied spout, rst place the rubber gasket on the bottom of the spout and

make sure it is properly seated in its groove. Put the spout in through the hole in the tub shell

(shown in the drawing above). Install the rubber washer and then the brass mounting nut.

Locate the water line from the spout diverter and connect it to the threading on the bottom

of the spout. Tighten all ttings and check for leaks.

*NOTE: Rubber gasket only comes with the Elite, Royal and Petite models. Spout must be

tightened down prior to installation of tub.

WARNING: Do not over tighten the water supply line. To tighten properly, it should be hand

tight plus about a half a turn.

Installation of Spout

Mixing

Control Valve

Spout

Diverter

Spout

Water Line

Nut

Tub

Shell

Rubber Gasket

Spout

Rubber Washer

Hand Mixer

Diverter

Cold

Hot

Pull Out

Hand Shower