Installation Guide

Operating Instructions
www.ellasbubbles.com Page 15 03/18
1. Thermostatic Control Valve:
Before turning on the water, please adjust the thermostatic control valve to the desired
water temperature. To raise the temperature above the preset 100.4 Fahrenheit, press and
hold in the button handle while turning. For hotter water turn counterclockwise. Conversely,
turn the valve clockwise for colder water. The thermostatic control valve is pre-set to 100.4
Fahrenheit for your safety.
Button Handle
Round Knob
2. Using the Door:
Entering the walk in bath, the door can be closed and locked with the handle from a seated
or standing position. Do not apply any body weight on the door when entering or exiting
the walk in bath. The door hinges are well built and are very durable, however leaning on or
applying weight on the door may damage and mis-align the door and create leaks. Such
damages are not covered by the warranty.
3. Using the Diverter Valves:
Close the door and ll up the bathtub with water by moving the faucet diverter handle in
to the ON position.
The faucet and hand shower may be used individually or at the same time.
4. Using the Pull out Hand Held Shower:
To use the pullout hand held shower turn its diverter handle to the ON position. The hand
held shower is equipped with a 5 ft. long retractable ex hose. The pressure of the shower
can be adjusted by turning the round shower head of the hand unit.
WARNING: Do NOT attach the hand held shower to the wall. This may cause water to
leak behind your walk in tub.
*The button knob stops here at 100.4 Fahrenheit. To adjust to a hotter temperature past 100.4 F,
press the button knob in while turning the handle counter clockwise
*
ON OFF
- On / Off Diverter Positions -
For both the faucet and the hand shower
ON
OFF