Installation Guide

Operating Instructions Continued
www.ellasbubbles.com Page 16 03/18
5. Using the Hydro Massage:
To activate and deactivate the hydro massage pump, push the on/off the control button
(Page #9). There are two types of hydro jets in your walk in bath; adjustable and non-
adjustable types. Simply push on the head of an adjustable jet and turn the head in the
desired position. The in-line water heater will activate with the Hydro pump. An air ow rate
control dial can be found over the shoulder of the seating area. Turning the knob clockwise
will reduce the amount of air introduced into the hydro system. Adjust according to personal
preference.
6. Using the Air Massage
To activate and deactivate the air massage pump, push the on/off control button (Page
#10). Notice, when adding cool air into the bath water it can lower the water temperature.
7. Using the Ozone Sterilization
To activate and deactivate the ozone sterilization, turn on the hydro jets. The ozone sterilization
will run automatically in the background during your hydro massage. (Page #12). Turn the
ozone on for 10 minutes for every 30 minutes of tub use.
8. Using the LED system
The LED Chromatherapy light system may be controlled manually. Push the on/off
control button (Page # 11).
9.Draining the Walk in Bath
To drain your Ella Walk in Bath. Begin by turning OFF the massage systems. Open each of the
drains by turning the drain openers clockwise from a down position, upward one half turn
until fully open. Remain in the tub until the water has dropped below the door sill.
10. Exiting the Bath
Getting out of your Ella Walk in Bath is as easy as getting in to it. Wait for the water to drain
below the door sill. Unlock the door by using the door handle. Fully open the door rst then
stand up and exit your Ella Walk in Bath.
NOTE: It is recommended to leave the door fully open when not in use to keep the door
seal fresh and promote a longer lifetime for the door seal.