Manualshelf

Installation Guide

ManualsBrandsElla ManualsBathMalibu 52 in. Walk-In MicroBubble and Air Bath in White with RHS Outward Swing Door, Heated Seat, Faucet, RHS Dual Drain
19202122232425262728
TOUCHSTONE Dual Load Bath Control System
Configuration #1 Owner’s Manual
Electronic Keypad Operating Instructions
Keypad Backlighting: When in Standby, the keys are not lighted.
When in use, Blue keys indicate "No Water Detected", and Green keys
indicate "Water Is Detected". When a function is in use, its key will light
Red. When a fuction is off, its key will light Blue or Green as noted
above.
Single Speed Pump (Water): The Whirlpool
Water System is
activated by pressing the Water System
Button. Ensure first that there is sufficient
water in the Tub to at least cover the Jets. (If not, the Water Detection
Function will prevent the Pump from starting dry, and the Button will
flash Red/Blue to alert you). This will turn on the Pump, and activate its
20-minute timer. The Whirlpool Water System will stop automatically
when the timer expires. To turn off this function earlier, press the Water
System Button at any time.
Variable-Speed Air Blower (Air): Th
e Air
system is activated by pressing the Air
Button. (The Air System runs independantly
of the Tub Water Level). This will turn on the
Blower, and activate its 20-minute timer. To change the Speed of the
Blower, press and hold the "+" or "-" Buttons accordingly. Release at
the desired speed. To activate the "Massage Mode", press and hold the
"+" and "-" Buttons together, pause, then release. To turn off the Air
System earlier, press the Air Button at any time.
Automatic Dry Cycle: 15 minutes after the Water and/or Air
systems are turned off, or the tub is drained, the Air Blower will
automatically come on for 2 minutes. This will purge out any residual
moisture in the air system, making the system fresh and ready for the
next bath.
Multi-color Tub Light (Light): The LED
Multi-Color Tub Light is activated by pressing
the Light Button. (The Tub Light runs
independantly of the Tub Water Level). The
first press will start its 60-minute timer, and
activate the Tub Light in a “Rainbow” mode. Subsequent presses will
change the color to Blue, White, Blue, Aqua, Green, Yellow, Red,
Magenta, and off. The Tub Light will turn off automatically when the
timer expires. To turn off this function earlier, press and hold the Light
Button at any time.
Page 22