User's Manual
Table Of Contents
- 1. Safety Information
- 2. New Order Contents
- 3. TrackSense® LyoPro 10-Slot Reader Station
- 4. Activating ValSuite®
- 5. How to Start Logging Data with TrackSense LyoPro
- 6. TrackSense® LyoPro Loggers
- 6.1. TrackSense® LyoPro
- 7. Battery
- 8. Calibration
- 9. Accessories
- 10. Examples on how to Configure LyoPro Using LyoStopper or Various LoggerClips
- 11. Firmware Update
- 12. Ellab Service Contract
- 13. Technical Specifications
- 14. FAQ
- 15. Changelog
TrackSense
®
LyoPro Version 3.3 Page 32 of 53
User Manual User Manual TrackSense LyoPro – MAN 7
WARNING: When returning an ETS to Ellab for service or recalibration,
please use the suitcase delivered with the product in order to avoid
damage. If the product does not arrive at Ellab in a case, all warranty is
lost and Ellab reserves the right to include a suitcase at the user’s
expense upon returning the product.
8.2.1.3. Setting up the ETS
The ETS can be setup in 3 different ways. It can be used as a standalone
unit with a display, in connection with the ETS Suite software or it can
be setup in connection with the ValSuite software.
Setup – Stand Alone Unit w/ Display:
1. Connect the ETS using a USB cable to the ETS display
2. Connect the display to the power supply
Setup – ETS using ETS Suite:
Note: USB drivers must be installed first for firmware versions older
than 2.0.
1. Connect the ETS to the PC via USB cable
2. Verify that the ETS Suite is detecting the connected ETS
Setup – ETS using ValSuite:
1. If using the USB connection, install the Ellab USB driver first
2. Disconnect all the equipment
3. The driver can be found on the ValSuite USB Key