User's Manual

TrackSense
®
LyoPro Version 3.3 Page 4 of 53
User Manual User Manual TrackSense LyoPro – MAN 7
1. Safety Information
Use this equipment only as specified in this manual. Otherwise, the protection
provided by the equipment may be impaired.
• “Warning” identifies conditions and actions that may pose hazards to the user
• “Caution” identifies conditions and actions that may damage the equipment
being used
1.1. Warnings
Disclaimer: Ellab manufactures equipment intended for use in thermal
validation, monitoring and stability studies. Equipment used for applications
other than these studies is used at the discretion and sole responsibility of the
customer. Ellab cannot accept any responsibility for the use of equipment for
any application other than thermal validation, monitoring and stability studies.
The customer needs to verify the temperature range of the equipment being
used before placing it into an application.
1.2. General
DO NOT use the equipment for any application other than its intended use, e.g.
thermal validation, monitoring and stability studies. Any other use of the
equipment may cause unknown hazards to the user.
DO NOT use the equipment in environments other than those listed in this
user’s guide and follow all safety guidelines. Only trained personnel should use
the equipment. Inspect the equipment for damage before each use.
DO NOT use the equipment if it appears damaged or operates abnormally.
Before initial use, after transport, or after storage in humid or semi-humid
environments, the equipment needs to be dried for a period of at least 2 hours.
If the equipment is wet or has been in a wet environment, take necessary
measures to remove moisture prior to applying power. The equipment is
intended for indoor use only.