User's Manual

TrackSense
®
LyoPro Version 3.3 Page 8 of 53
User Manual User Manual TrackSense LyoPro – MAN 7
L’émetteur/récepteur exempt de licence contenu dans le présent appareil est
conforme aux CNR d’Innovation, Sciences et Développement économique
Canada applicables aux appareils radio exempts de licence. L’exploitation est
autorisée aux deux conditions suivantes :
1. L’appareil ne doit pas produire de brouillage ;
2. L’appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d’en compromettre le fonctionnement.
1.4.4.1. FCC and ISED Applicable to TrackSense LyoPro Access Point
FCC: To comply with FCC RF exposure requirements this device with its
antennas must be installed and operated with a min separation distance of
20 cm to any human body.
ISED: To comply with ISED RF exposure requirements this device with its
antennas must be installed and operated with a min separation distance of
20 cm to any human body.
This radio transmitter [IC: 8758A-LYOAP1] has been approved by Innovation,
Science and Economic Development Canada to operate with the antenna
types listed below, with the maximum permissible gain indicated.
Antenna types not included in this list that have a gain greater than the
maximum gain indicated for any type listed are strictly prohibited for use
with this device. Monopole Antenna / 2144150011 Molex / 5.3 dBi.
1.4.5. ARIB
Ellab LyoPro equipment has been tested to comply with the
requirements in the Japanese standard ARIB STD-T66 (Low-Power Data
Communication System/Wireless LAN System).
1.5. Ellab Service
Please contact your local Ellab sales representative for the proper service
center location. Contact information can be found at www.ellab.com
.
When contacting Ellab for support, please have the following information
available:
• Model Number
• Serial Number
• Voltage
• Complete description of the problem
• ValSuite Software Version