User's Manual
Table Of Contents
- 1. Safety Information
- 2. New Order Contents
- 3. TrackSense® LyoPro 10-slot Reader Station
- 4. Activating ValSuite®
- 5. How to Start Logging Data with TrackSense LyoPro
- 6. TrackSense® LyoPro Loggers
- 6.1. TrackSense® LyoPro
- 6.1.1. Data Logger Specifications
- 6.1.2. Proper Use
- 6.1.3. Data Logger Serial Numbers
- 6.1.4. Disassembling / Assembling Data Loggers
- 6.1.5. Procedure for Cleaning TrackSense® LyoPro Data Loggers
- 6.1.6. Procedure for Changing the Data Logger O-Ring
- 6.1.7. Extended Warranty
- 6.1.8. Thermocouple Sensor
- 6.1.9. -30 to -80 C Application Recommendations
- 6.1. TrackSense® LyoPro
- 7. Battery
- 8. Calibration
- 9. Accessories
- 10. Examples on how to Configure LyoPro with Appropriate Accessories
- 11. Firmware Update
- 12. Ellab Service Contract
- 13. Technical Specifications
- 14. FAQ
- 15. Changelog
TrackSense
®
LyoPro Version BETA Page 19 of 46
User Manual User Manual TrackSense LyoPro – MAN 7
6.1.2. Proper Use
• Never use the data loggers outside their designated temperature
range. Damage may occur to the electronics and can cause out-
gassing of the battery
• Treat the data loggers as you would any other sensitive electronic
equipment. Dropping or exposing them to heavy mechanical shock
may loosen or damage the electronic connections
• Check the o-rings and replace them when necessary
• Do not remove data loggers from the reader station while they are
being read. Doing so may result in loss of data
• Store data loggers in a dry and cool place
• If corrosion is present near the battery contacts, verify that the data
logger is not leaking. Lightly clean the area using a cotton swab and
alcohol, then change the o-rings
• Any data logger with recurring problems should be returned to Ellab
for service
• When data loggers have not been used for an extended period of
time, they must be tested every three months by running a short test
at room temperature
• When data loggers are not used for a period of two or more weeks,
remove the battery from the data logger. If the battery is removed
from the logger for more than one week, the activation tool will be
needed to re-activate the battery
6.1.3. Data Logger Serial Numbers
All data loggers have a unique serial number. The serial number allows
compliance with GMP & GDP regulations. The serial number for the
TrackSense LyoPro data logger is located on the side of the black housing.
The data logger serial
number can be found here