User's Manual

TrackSense
®
LyoPro Version BETA Page 5 of 46
User Manual User Manual TrackSense LyoPro – MAN 7
1.3. Electrical Hazards
These guidelines must be followed to ensure that the safety mechanisms in the
equipment will operate properly. Equipment, when applicable, must be
plugged into a 115 VAC (± 10%) or 230 VAC (± 10%) 50/60 Hz electric outlet
as indicated on the label. The power cord of the instrument is equipped with a
three-pronged grounding plug for your protection against electrical shock
hazards. It must be plugged directly into a properly grounded three-prong
receptacle. The receptacle must be installed in accordance with local codes and
ordinances.
DO NOT use an extension cord. Consult a qualified electrician. Always inspect
the power cord before use for any damage to the insulation due to contact with
hot surfaces, cuts or abrasions. Always replace the power cord with an
approved cord of the correct rating and type. If you have questions, contact an
Ellab Authorized Service provider.
Cautions:
Always operate TrackSense
LyoPro Reader Stations at room temperature
between 5 °C and 50 °C (41 °F and 122 °F).
DO NOT operate this equipment in an excessively wet, oily, dusty, or dirty
environment. The equipment is a precision instrument. Although it has been
designed for optimum durability and trouble-free operation, it must be handled
with care. The equipment including any probes or loggers are sensitive
instruments that can easily be damaged. Always handle these devices with
care. Do not allow them to be dropped, struck, stressed or overheated.
TrackSense Clock (Internal)
When using TrackSense LyoPro loggers, ValSuite will start an internal clock in
the logger. Beware that the max time deviation at 23 °C will be +/- 5 seconds
over 24 hours.