User's Manual

TrackSense
®
LyoPro Version BETA Page 6 of 46
User Manual User Manual TrackSense LyoPro – MAN 7
1.4. Directives
1.4.1. EMC
Ellab equipment has been tested to meet the European Electromagnetic
Compatibility Directive (EMC Directive, 2014/30/EU). The Declaration of
Conformity for your instrument lists the specific standards at which the unit
was tested.
1.4.2. Low Voltage (Safety)
In order to comply with the European Low Voltage Directive (LVD)
2014/35/EU), Ellab equipment has been designed to meet the EN 61010-1
standard.
1.4.3. Waste Electrical and Electronic Equipment
Ellab meets the European Community directive 2012/19/EU
on waste electrical and electronic equipment (WEEE), and is in
accordance with the RoHS Directive 2011/65/EU, which is
European Law since February 2003.
• The maximum pressure under which the TrackSense LyoPro may be
operated is 4 Bar ABS
• Permitted range of ambient temperature: -80 °C ≤ T
amb
≤ +60 °C (short
term up to +121°C)
1.4.4. Important Notice Regarding Ellab LyoPro Equipment
FCC ID: XUS-LYODL1 and FCC ID: XUS-LYORS1
Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference
that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio