Computer Hardware User Manual

1.3 Directives and Standards
The Dragonfly and Butterfly conform to the following industry safety standards:
Safety Standard Item
In compliance with MIL-STD-704
Aircraft, Electric Power Characteristics
In compliance with MIL-STD-810
Environmental Engineering Considerations and
Laboratory Tests
In compliance with MIL-STD-1275
Characteristics of 28 Volt DC Electrical Systems in
Military Vehicles
In compliance with MIL-STD-461
Requirements for the Control of Electromagnetic
Interference Characteristics of Subsystems and
Equipment
In compliance with MIL-HDBK-217
Reliability Prediction of Electronic Equipment
In compliance with ISO-9001:2000
Quality Management
In compliance with UL508c Power Conversion Equipment
In compliance with UL840
Insulation Coordination, Including Clearance and
Creepage Distances of Electrical Equipment
In compliance with UL60950-1
(formerly UL1950)
Safety of Information Technology Equipment,
Including Electrical Business Equipment
In compliance with EN60204-1 Low Voltage Directive, 73/23/EEC
The Dragonfly and Butterfly servo drives have been developed, produced, tested and
documented in accordance with the relevant standards. Elmo Motion Control is not
responsible for any deviation from the configuration and installation described in this
documentation. Furthermore, Elmo is not responsible for the performance of new
measurements or ensuring that regulatory requirements are met.
1.4 CE Mark Conformance
The Dragonfly and Butterfly servo drives are intended for incorporation in a machine or
end product. The actual end product must comply with all safety aspects of the relevant
requirements of the European Safety of Machinery Directive 98/37/EC as amended, and
with those of the most recent versions of standards EN60204-1 and EN292-2 at the least.
According to Annex III of Article 13 of Council Directive 93/68/EEC, amending Council
Directive 73/23/EEC concerning electrical equipment designed for use within certain
voltage limits, the Butterfly and Dragonfly meet the provisions outlined in Council
Directive 73/23/EEC. The party responsible for ensuring that the equipment meets the
limits required by EMC regulations is the manufacturer of the end product.
Dragonfly/Butterfly Installation Guide Safety Information
MAN-DRBUIG (Ver. 1.1)
1-3