Document Camera Instruction Manual

ENGLISH

BEFORE YOU USE

■ The power cord applicable to the local power specifications is attached. Be sure

to use the power cord applicable to your local power specification.

■ Do not leave this product under direct sunlight or by heaters, or this product may

be discolored, deformed, or damaged.

■ Do not place this product in any humid, dusty, windy or vibrating location. Use

this product in the following environmental conditions:

Temperature: 5°C~40°C (41°F~104°F)

Humidity: 30%~85% (No condensation)

■ In handling (including setting up and storing) or carrying the camera, be

meticulously careful not to give an impact on the camera head.

■ To prevent dropping and falling, observe the following:

• Use the camera on a stable stand, desk or table. Never put the camera on

any shaky stand or inclined or instable place.

• Before using, lay out the power cord, the AC adapter cable and the video

cable not to be pulled, and wire them accordingly.

■ Use a soft, dry cloth for cleaning. Do not use any volatile solvent, such as thinner

or benzine.

■

Do not directly point the camera lens into the sun, or the camera may be damaged.

■ Caring for the batteries:

• If this product is not used for a long time, take out the batteries from the

wireless remote control.

• Do not use rechargeable Ni-Cd batteries.

•

Do not use new and old batteries, or batteries of different types together.

• Do not try to recharge or short-circuit the batteries.

■ Luminescent and Black Spots

This camera has a CMOS area image sensor and a color LC panel, which are

composed of many pixels. Some of these pixels may not operate normally. As a

result, a luminescent spot or a black spot may appear on the output screen.

However, this is a phenomenon unique to the CMOS area image sensor and

color LC panel and therefore this phenomenon is not faulty.

■ Do not press the LC panel strongly or with a sharp-pointed object, or it would

cause break or failure to the color LC panel.

■ Transfer the data in an SD card to a PC or other data storage means for backup

purpose. Note with care that the data in the SD card could be lost due to failure

or repair of this product.