Instruction manual

- 21 -
[ 2 ] CAMERA1
Name Factory Settings Function
[ 1 ] MAIN CONTROL
Name
Factory Settings Function
OFF
To turn ON/OFF the settings of the RS-485 terminating
resistance contained in the Camera main unit.
(For the telecommunication equipment to be connected
to the RS-485 interface, a terminating resistance should
be attached to both ends of the equipment having the
longest route to prevent signal damping.)
4 RS-485 END
0
To set the ID No. [1 – 9] for the Camera main unit for
selective operation by using the wireless remote
controller. When the ID No. is not to be set, input [0].
Up to 9 Cameras can be controlled selectively with one
wireless remote controller.
5 REMOTE ID
OFF6 OFF TIME
OFF
To set the time of automatic return to the home position
[OFF, 30s, 1min, 2min, 5min, 10min, 20min, 30min]
If it has passed over this set time with no operation after
the PAN-TILT-ZOOM operation, the Camera will return
automatically to the home position. The home position
can be registered freely with the preset No. “0.”
To set the time of the Low Power Consumption mode
[OFF, 40min, 1h, 2h, 3h, 4h, 5h] If it has passed over this
set time with no operation, the Camera power will be
turned OFF automatically. (When POWER button is
pressed again, the Camera power is turned ON again.)
7
AUTO RETURN
OFF
OFF
When this function is set to [ON], the setting of each item
of [CAMERA2] can be registered in its preset position.
(Set this button to [ON/OFF].)
To set the maximum magnification [OFF, ×1.5, ×2, ×2.5,
×3, ×4, ×6, ×8, ×16]
When TELE button on the wireless remote controller
is held down, the optical zoom ×12 enters automatically
from its end point into the digital zoom area.
8 CAMERA2
PRESET
1 E-ZOOM MAX
13
1