Instruction manual

- 30 -

[1] Initializing the settings

When the 4P DIP switch No. 2 located on the bottom of the main unit is set to [ON] and the

Camera power is turned ON, the PAN-TILT settings, the lens settings, the preset settings,

and the Camera settings made in the OSD menu are reset to the factory settings. Then, set

the DIP switch No. 2 to [OFF].

Note: After initialization, be sure to set the DIP switch No. 2 to [OFF]. If it is

left in [ON], each time the Camera power is turned ON, the settings

will be initialized and cannot be saved.

Note: For the unused switches of the DIP switch, be sure to set to [OFF].

9. SETTING OF VARIOUS MODES

Pin assignment

1 OFF Leave in OFF

2 OFF ON OFF To initialize the settings

3 OFF Leave in OFF

4 OFF Leave in OFF

Pin No. Normal Operation Function

Setting Initialization mode

OFF

234

Bottom of the main unit

4P DIP switch