Instruction manual

- 32 -
No operation via
wireless remote
controller
B&W image
If the sunlight or the fluorescent lamp light of the
inverter enters the infrared sensor, the signal from
the wireless remote controller could not be sensed
normally. If yes, block the light, and then operate
the wireless remote controller.
Symptom
P. 28
Isn’t the 4P DIP switch No. 1 located on the
bottom of the main unit set to [ON]? If yes, the
wireless remote controller cannot be operated.
P. 30
Isn’t [PAN TILT] – [PRESET STILL] set to [ON] in
the OSD menu? If yes, the PAN-TILT-ZOOM
operation is disabled.
P. 26
This Camera has the B&W/color switching
function. Check the settings.
P. 22
No switching to
B&W image
Isn’t [CAMERA1] – [ICR] set to [OFF] in the OSD
menu? If yes, the DAY/NIGHT function is disabled.
P. 22
Frequent
color/B&W
screen
Isn’t the infrared illumination intensive? Increase
the numeric of [CAMERA1] – [AUTO LEVEL] in
the OSD menu.
P. 22
Shimmer when
imaging
fluorescent
When [CAMERA1] – [HS-SHUTTER] is set to
[OFF] in the OSD menu, the shimmer will be
eased by setting the shutter speed to [1/100s].
(However, since this will change the brightness,
the iris operation may be required.)
P. 22
No adjustment
of preset
position
The Camera head direction may have been
changed by hand. Correct the position by pressing
the RESET button on the wireless remote
controller.
P. 17
Ref. PageChecking Point
Isn’t wrong ID number set?
Check the remaining battery power of the wireless
remote controller.
P. 19
P. 7
If the problem still remains after checking the above and apply the remedy, consult our
dealer from whom you have purchased the Camera or our branch office or sales office
nearest to you.