User manual

3.10 Auxiliary Feedback (bi-directional)
When using one of the Auxiliary Feedback options, the relevant functionality of the Auxiliary
Feedback's ports are software selected for that option. Refer to the SimplIQ Command Reference
Manual for detailed information about Auxiliary Feedback setup.
The Auxiliary Feedback connector has two ports – B1 and B2.
• Port B1 has three pairs of differential buffered inputs
• Port B2 has three pairs of differential buffered outputs
There are two modes of operation for this interface:
• Mode 1 (Composer Command: YA[4]=4) see 3.10.2
When the Auxiliary port of the Whistle is set by the software to act as an emulated
encoder output (this is practical only when using Resolver or Analog-Encoder as the
Main Feedback):
 B1 input becomes inactive
 B2 presents emulated differential buffered encoder output signals of the Main
Feedback
• Mode 2 (Composer Command: YA[4]=2 or YA[4]=0) see 3.10.3 & 3.10.4
When the Auxiliary port of the Whistle is set by software to act as an input
 B1 becomes an active differential buffered input
 B2 presents differential buffered encoder output signals of B1
Duo User Guide
MAN-DUOUG (Ver. 1.0)
3-17