Installation Guide Owner manual

DC Whistle Installation Guide Installation
MAN-DCWHIIG (Ver. 1.101)
www.elmomc.com
33
3.10.1. Main and Auxiliary Feedback Combinations
The Main Feedback is always used in motion control devices whereas Auxiliary Feedback is
often, but not always used. The Auxiliary Feedback connector has two ports (B1 and B2). When
used in combination with Main Feedback, the Auxiliary Feedback can be set, by software, as
follows:
Main Feedback Auxiliary Feedback: Output
Software
Setting
YA[4] = 4
(Auxiliary Feedback: output)
Incremental
Encoder Input
N/A
Interpolated
Analog
(Sine/Cosine)
Encoder Input
Resolver Input
Potentiometer
Tachometer
Input
N.A
Typical
Applications
 Analog Encoder applications where position data is required, in the Encoder’s
quadrature format, for other purposes such as position controllers and/or
other drives.
 Resolver applications where position data is required in the Encoder’s
quadrature format, for other purposes such as position controllers and/or
other drives.
B2 – output Analog Encoder position data
emulated in differential, buffered, incremental
Encoder format
B1 – not available
Main Feedback: Analog Encoder
B2 – output Resolver position data emulated in
differential, buffered, incremental Encoder
format
B1 – not available
Main Feedback: Resolver

