Operation Manual

38
Built-in Needle Threader
Hand turn the flywheel (always turn towards you) to bring
the needle up to its highest position. Turn OFF the power
switch. Lower the presser foot.
Pull down the needle threader lever
q as far as it will go.
Hook w is automatically inserted into the needle eye.
Bring the thread around guide e and under hook w.
Slowly release the lever while holding the thread end and
let the needle threader return to its original position. A loop
of thread r is pulled through the needle eye.
Pull the thread loop off the guide to the back and manually
bring the thread through the needle eye.
NOTE: The needle threader can be used with #11 to #16
size needles. Thread weight may vary from 30 to 90.
If the needle threader does not catch a thread loop, check
the needle and positioning.
q
w
e
w
r