User manual

T51prog2

Technical specification

HARDWARE

Socket, pin drivers and DACs

• two D/A converters for VCCP and VPP, controllable rise and fall time

• VCCP range 0..7V/350mA

• VPP range 0..25V/200mA

• USB 2.0/1.1 compatible interface

• selftest capability

ZIF socket, pindriver

• 40-pin DIL ZIF (Zero Insertion Force) socket accepts both 300/600 mil devices up to 40-pins

• pindriver: 40 TTL pindrivers, universal GND/VCC/VPP pindriver

• FPGA based TTL driver provides H, L, CLK, pull-up, pull-down on all pindriver pins, level H

selectable from 1.8 V up to 5V

• continuity test: each pin is tested before every programming operation

ISP connector

• 10-pin male type with miss insertion lock

• 6 TTL pindrivers, provides H, L, CLK, pull-up, pull-down; level H selectable from 1.8V up to

5V to handle all (low-voltage including) devices.

• 1x VCCP voltage (range 2V..7V/100mA) and 1x VPP voltage (range 2V..25V/50mA)

• programmed chip voltage (VCCP) with both source/sink capability and voltage sense

DEVICE SUPPORT

Programmer, in ZIF socket

• microcontrollers MCS51 series: 87Cxxx, 87LVxx, 89Cxxx, 89Sxxx, 89LVxxx, LPC series

from Atmel, Atmel W&M, Intel, Philips, SST, Winbond, ... 8-40 pins (*1)

• microcontrollers Atmel AVR: ATtiny, AT90Sxxx, ATmega series (parallel and serial mode),

8-40 pins (*1)

• Serial E(E)PROM: 24Cxxx, 24Fxxx, 25Cxxx, 59Cxxx, 85xxx, 93Cxxx series

Programmer, through ISP connector

• Microcontrollers Atmel: AT89Sxxx, AT90Sxxxx, ATtiny, ATmega series

• Microcontrollers Philips: LPC series

Note:

For all supported devices see actual Device list on

www.elnec.com.

Programming speed

Device Operation Time

AT89C52 programming and verify 17 sec

T87C5111 programming and verify 14 sec

Conditions: P4, 2,4GHz, USB 2.0 HS, Windows XP