User manual

PIKprog2

These specifications correspond with Microchip application note: In-Circuit Serial

Programming™ (ICSP™) Guide. Used application note you may find on

www.elnec.com,

section Support / Application Notes.

Note: Pin no. 1 is signed by triangle scratch on ISP cable connectors.

ISP cable of PIKprog2

Warnings:

• When you use PIKprog2 as ISP programmer, don’t insert device to ZIF socket.

• When you program devices in ZIF socket, don’t insert ISP cable to ISP connector.

• Use only attached ISP cable. When you use other ISP cable (other material, length…),

programming may occur unreliable.

• PIKprog2 can supply programmed device only, but target system cannot supply

PIKprog2.

• PIKprog2 apply programming voltage to target device and checks his value (target system

can modify programming voltage). If the programming voltage is different as expected, no

action with target device will be executed.

Note: H/L/read PIKprog2 driver

H/L/read driver

in programmer

pin of ISP

connector

PU/PD driver

in programmer

C1=1nF, R1=1k3, R2=22k

Selftest

If you feel that your programmer does not react according to your expectation, please run the

programmer selftest using Diagnostic POD, enclosed with the standard delivery package.

• Insert 40 pins diagnostic POD - type I into ZIF socket of the programmer. 40 pins

diagnostic POD - type I must be inserted as 40 pins device.

• Run selftest of programmer in Pg4uw (Programmer / Selftest plus).