User manual

ELNEC s. r. o.

Technical specification

HARDWARE

Socket, pin drivers and DACs

• two D/A converters for VCCP and VPP, controllable rise and fall time

• VCCP range 0..7V/350mA

• VPP range 0..25V/200mA

• USB 2.0/1.1 compatible interface

• selftest capability

ZIF socket, pindriver

• 40-pin DIL ZIF (Zero Insertion Force) socket accepts both 300/600 mil devices up to 40-pins

• pindriver: 40 TTL pindrivers, universal GND/VCC/VPP pindriver

• FPGA based TTL driver provides H, L, CLK, pull-up, pull-down on all pindriver pins, level H

selectable from 1.8 V up to 5V

• continuity test: each pin is tested before every programming operation

ISP connector

• 10-pin male type with miss insertion lock

• 6 TTL pindrivers, provides H, L, CLK, pull-up, pull-down; level H selectable from 1.8V up to

5V to handle all (low-voltage including) devices.

• 1x VCCP voltage (range 2V..7V/100mA) and 1x VPP voltage (range 2V..25V/50mA)

• programmed chip voltage (VCCP) with both source/sink capability and voltage sense

DEVICE SUPPORT

Programmer, in ZIF socket

• microcontrollers MicrochipTM PICmicro®: PIC10xxx, PIC12xxx, PIC14xxx, PIC16xxx,

PIC17xxx, PIC18xxx, dsPIC series, 8 to 40 pins (*1)

• Serial E(E)PROM: 17Cxxx, 24Cxxx, 24Fxxx, 25Cxxx, 59Cxxx, 85xxx, 93Cxxx series

Programmer, through ISP connector

• Microcontrollers Microchip PICmicro: PIC10xxx, PIC12xxx, PIC16xxx, PIC17xxx, PIC18xxx,

dsPIC series

Notes:

• (*1) - suitable adapters are available for non-DIL packages and devices with more than 40

pins

• For all supported devices see actual Device list on