User manual

UserManual:1528L

SW200095RevA,Page37of39

This equipment has been tested to the requirements for the CE Mark as

required by Low Voltage Directive (LVD) 2006/95/EC indicated in

European Standard EN60950-1 and the EMC Directive 2004/108/EC

indicated in European Standard EN55022, EN61000-3-2, EN61000-3-3

and EN55024.

D) General Information to all Users: This equipment generates, uses and

can radiate radio frequency energy. If not installed and used according to

this manual the equipment may cause interference with radio and television

communications. There is, however, no guarantee that interference will not

occur in any particular installation due to site-specific factors.

1) In order to meet emission and immunity requirements, the user must

observe the following:

a) Use only the provided I/O cables to connect this digital device with

any computer.

b) To ensure compliance, use only the provided manufacturer’s

approved power cord.

c) The user is cautioned that changes or modifications to the

equipment not expressly approved by the party responsible for

compliance could void the user’s authority to operate the equipment.

2) If this equipment appears to cause interference with radio or television

reception, or any other device:

a) Verify as an emission source by turning the equipment off and on.

b) If you determine that this equipment is causing the interference, try

to correct the interference by using one or more of the following

measures:

i) Move the digital device away from the affected receiver.

ii) Reposition (turn) the digital device with respect to the affected

receiver.

iii) Reorient the affected receiver’s antenna.

iv) Plug the digital device into a different AC outlet so the digital

device and the receiver are on different branch circuits.

v) Disconnect and remove any I/O cables that the digital device

does not use. (Unterminated I/O cables are a potential source of

high RF emission levels.)

vi) Plug the digital device into only a grounded outlet receptacle.

Do not use AC adapter plugs. (Removing or cutting the power

cord ground may increase RF emission levels and may also

present a lethal shock hazard to the user.)

If you need additional help, consult your dealer, manufacturer, or an

experienced radio or television technician.