User manual

User Manual – 1929LM

SW200158 Rev A - Page 26 of 31

iv) Plug the digital device into a different AC outlet so the digital device and the receiver are on

different branch circuits.

v) Disconnect and remove any I/O cables that the digital device does not use.(Un-terminated

I/O cables are a potential source of high RF emission levels.)

vi) Plug the digital device into only a grounded outlet receptacle. Do not use AC adapter plugs.

(Removing or cutting the line cord ground may increase RF emission levels and may also present a

lethal shock hazard to the user.)

If you need additional help, consult your dealer, manufacturer, or an experienced radio or

television technician.

III. Agency Certifications

The following certifications and marks have been issued or declared for this monitor:

 CE marking to low voltage directive and EMC directive

 US "NRTL" mark (e.g. UL)

 Canadian “NTRL” mark (e.g. CSA) and ICES EMC labeling

 US FCC, EMC compliance label

 China CCC safety mark and China RoHS marking

 Australia/NZ RCM mark

 WEEE marking

 Korea KC mark EMC

 Russia EAC mark

 Taiwan BSMI mark

 Japan VCCI mark