User manual

User Manual: X-Series Rev A AiO Touchcomputer
SW602213 Rev A, Page 31 of 51
Magnetic Stripe Reader KIT (E001002)
You can add a magnetic stripe reader (MSR) to the X-Series touchcomputer to any of the three
mounting locations located on the display head top, left, and right. Software application and
drivers can be found in the following directory or on www.elotouch.com
C:\EloTouchSolutions\Peripherals
The MSR is a USB 2.0 device that reads all three data stripes on standard credit cards or
driver’s licenses conforming to ISO/ANSI standards. The MSR has foreign language capability.
The credit card is read by sliding the credit card forward or backward through the MSR, stripe
side toward the display. The MSR is powered from the USB port; no external power is needed
The MSR specifications are shown in below table.
Feature
Spec Description
Swipe Speed
4~60 ips (10.1~152.4 cm/sec), Bi-direction
Card Width
0.025 ~0.035 inches
Number of Tracks
3 Tracks
Encryption
Triple DES encryption Device & Host
Authentication Tokenization
Power supply
5.0VDC +/- 0.25V
Power consumption
< 2.0 W
Current draw
< 40 mA
Current draw - Suspend
mode
< 500 uA
Interface type
Compatible with USB, HID specification
Encrypts security
Level 2
Operating temperature
-20°C to 80°C
Encoded data compliance
ANSI/ISO/AAMVA standards
Reliability
> 1000K times swipes