User's Manual

UM600106
Rev. A, page
9
of
32
User Manual – i-series 2.0
Power
Press the power button to turn the Elo i-series 2.0 on. Press and hold power button when the system is on to bring up the Shut Down option popup.
In the event that the system freezes and does not respond, press and hold the power button until the system turns off. If the system does not turn
off via the power button, the system will need to be powered down by unplugging the power cord from the wall.
The Elo I-series 2.0 power button is equipped with an LED that indicates the power status of the system, as follows:
Register power status Led status
OFF (disconnected from wall) Off
OFF (connected to wall) Red (Solid)
SLEEP White (Blinking)
ON White (Solid)
The system consumes low power when in SLEEP and OFF modes. For detailed power consumption specifications, refer to technical specifications
available on the Elo website www.elotouch.com.
To bring the system out of sleep/standby mode, press the power button once. If the system is in sleep mode, touching the screen will wake up the
system
If long periods of non-use are planned, turn off and unplug the Elo I-series 2.0 to save power.
The maximum voltage, frequency and current for the systems, are provided in the power ratings table below:
Product Operating Voltage Range Operating Frequency Range Operating Current Range
10.1in 100 - 240Vac 50 – 60 Hz
15.6in 100 - 240Vac 50 – 60 Hz
21.5in 100 - 240Vac 50 – 60 Hz
Eloview Engine 100 - 240Vac 50 – 60 Hz