User's Manual

User Manual:Elo
®
Tablet
SW602113 Rev A, Page 37 of 40
This equipment complies with the Class B limits for radio noise emissions from digital apparatus
as established by the Radio Interference Regulations of Industrial Canada.
Notice to Users in the European Union:
Use only the provided power cords and interconnecting cabling provided with the equipment.
Substitution of provided cords and cabling may compromise electrical safety or CE Mark
Certification for emissions or immunity as required by the following standards:
This Information Technology Equipment (ITE) is required to have a CE Mark on the
Manufacturers label which means that the equipment has been tested to the following
Directives and Standards: This equipment has been tested to the requirements for the CE Mark
as required by EMC Directive 2004/108/EC asindicated in European Standard EN 55022 Class
B and the Low Voltage Directive2006/95/EC as indicated in European Standard EN 60950.
General Information to all Users:
This equipment generates, uses, and can radiate radio frequency energy. If not installed and
used according to this manualthe equipment may cause interference with radio and television
communications. There is, however, no guarantee that interference will not occur in any
particular installation due tosite-specific factors.
1. In order to meet emission and immunity requirements, the user must observe thefollowing:
a. Use only the provided I/O cables to connect this digital device with any computer.
b. To ensure compliance, use only the provided manufacturers approved line cord.
c. The user is cautioned that changes or modifications to the equipment not expressly
approved by the party responsible for compliance could void the user’s authority to
operate theequipment.
2. If this equipment appears to cause interference with radio or television reception, or any
otherdevice:
a. Verify an emission source by turning the equipment off and on.If you determinethat
this equipment is causing theinterference, try to correct the interference by using one
or more of the following measures:
I. Move the digital device away from the affected receiver.
II. Reposition (turn) the digital device with respect to the affected receiver.
III. Reorient the affected receiver’s antenna.
IV. Plug the digital device into a different AC outlet so the digital device and the
receiver are on different branch circuits.
V. Disconnect and remove any I/O cables that the digital device does not
use.(Unterminated I/O cables are a potential source of high RF emission
levels.)
VI. Plug the digital device into only a grounded outlet receptacle. Do not use AC
adapter plugs. (Removing or cutting the line cordground mayincrease RF
emission levels and may also present a lethal shock hazard to the user.)