Setup guide

Palette
Plus, Minus, @ (At), Full, Out Buttons 21
LIGHTING CONTROL CONSOLE INSTALLATION & SETUP GUIDE
CONSOLE BUTTONS
1. Plus, Minus, @ (At), Full, Out Buttons
• [FULL] and [OUT] will set the level of selected channels without having to press [ENTER].
• When editing split up/down times, use [FULL] to highlight the Wait time (start of line) and [OUT] to edit the Fade
time (end of line).
• Use [FULL] and [OUT] in dialog box edit boxes or combo boxes to take the value to its upper or lower limit.
• Use the [/] key to select a range of channels or to specify WAIT/FADE times in any time field.
• Use the [BACKSPACE] key to clear the command line and deselect any selected channels.
• Use the [-] key to enter ranges. For example, [1][/][10][@][0][-][100] = 1 thru 10 @ 0 to 100.
2. Arrow Buttons
• The arrow keys move the blue box in the cue list and patch displays.
• To change a value, press the [EDIT] button.
• Holding down the [SHIFT] key and pressing the up or down arrows selects a range.
• Once a range is selected, typing in a new value will change all cells to that value.
• If editing a numeric column (like time), after pressing [EDIT] use the [WHEEL] to change the values. If multiple
cells are selected, the values will change relative to each other. In the example below, if the WHEEL is used to
change the '3' to a '4', the '2' would change to a '3' and the '1' would change to a '2'.
• Holding down [SHIFT] while rolling the WHEEL on any numeric field will change the value by 0.1.
• Loads cues while in Blind - follows Blue Box.
3. Cue Button
• After pressing [RECORD], a Look or a Cue can be recorded.
• Recording a Cue is the default. If the [LOOK] button is selected, but a Cue is to be recorded instead, press the
[GOTO CUE] BUTTON.
• Pressing [SHIFT] [RECORD] opens the Record dialog box.
• Places the word "Cue" in the command line for setting attributes.
4. Dead Black Out Button
• Use this button to black out the stage.
• This button can be configured to work as a momentary button, a toggle button, or be disabled. See "Dead Black
Out (DBO)" on page 51 for setup details.
• The LED flashes when the Grandmaster slider is not at 100%. It flashes rapidly when the slider is at 0%.
5. Delete Button
• Use this button to delete cues and looks. Highlight the desired cue or look (or range) with the Blue Box using the
[ARROW KEYS] then press this button.