Setup guide

Palette
LIGHTING CONTROL CONSOLE INSTALLATION & SETUP GUIDE
22 CONSOLE BUTTONS
6. Edit Button
• Pressing this button allows changes to the highlighted cells in the cue list (times, labels, follows etc.) or in the
patch displays. Move the blue highlighted cells using the [ARROW KEYS].
• If a range is selected, typing in a new value will change all cells to that value.
• If editing a numeric column (like time), after pressing [EDIT] use the [WHEEL] to change the values. If multiple
cells are selected, the values will change relative to each other. In the example below, if the [WHEEL] is used to
change the '3' to a '4', the '2' would change to a '3' and the '1' would change to a '2'.
• Holding down [SHIFT] while rolling the [WHEEL] while editing cells will change numeric values by 0.1.
• [SHIFT] + [EDIT] changes to TIMES display for access of independent attribute times.
7. Go Button
• This button will do a GO on its cue list. (NOTE: The [SELECT] button does not have to be active [amber LED
On].)
• If a cue is running, the Green LED will be flashing.
• If you are sitting in a cue, the LED will be solid Green.
• If the cue list is Releasing, both the GO and the [HALT/BACK] LEDs will be flashing.
• [SHIFT] + [GO] asserts the cue list, grabbing full control of its attributes without advancing the cue list.
8. Goto Button
• Press [GOTO CUE] [#] [ENTER] to take the selected cue list to the desired cue.
• The Cue Number edit box will be preloaded with the cue number of the blue highlighted line.
• Using the [NEXT] key, a desired time for the cue to execute can be set. The recorded time is the default time.
9. Group Button
• Press [GROUP] then [#] [ENTER] to select the channels recorded in the Group Look page and place their intensi-
ties on the wheel. Alternately, these can be set to a level using the keypad. Example: [GROUP] [4] [@] [50]
[ENTER]
• Press [REC] then [GROUP] then a number to record a Look. The current levels will be stored in the Look, but if
you only want to use the selection (group), recall the Look using the group key.
• If you want traditional "Group at Level" functionality, press [LOOK] then the Look number.
• See "Show Options" in the PALETTE Software Help Menu for assigning look pages to this key.
10. Halt / Back Button
• The [HALT/BACK] button will halt any running cues on its cue list. A cue is running when the Green LED on the
GO button is flashing.
• If a cue list is halted (flashing Red LED), pressing this button again will back up the cue list.
• If the cue list is Releasing, both the [GO] and the [HALT/BACK] LEDs will be flashing.
• [SHIFT] + [BACK] will go to the previous cue in recorded time.