Specifications

110 Appendix Error! Main Document Only.Error! Main Document Only.6 - Optional
Software Protocols
280 V5.0 #2200<CR><LF>
For normal operation, this bit should be clear. BYTE2 is ignored when this bit is
set.
Axis Inversion
Bits 6 and 7 of BYTE1 are used to invert the X and/or Y axes. See Bit
Definitions, page 108.
Baud Rate
Bits 6 and 7 of BYTE2 are used to change the baud rate. If you do not wish to
change the baud rate during any software setup, then these bits must reflect the
current baud rate. See Bit Definitions, page 108.
When changing the baud rate, the host port must also be reconfigured to the new
baud rate.
Output Formats
The controller supports a variety of E261-280 output formats, including ASCII or
Binary, Single-Point or Stream Mode, and untouch reporting.
Bits 0 through 5 of BYTE2 are used to select a format code from the following
list. The default depends on the Binary/ASCII and Stream/Single-Point jumpers.
The Untouch Flag is included by default. Each of these modes is described in the
following sections.
Value (hex) Mode
00 ASCII/Single-Point/No Untouch Flag
01 ASCII/Single-Point/Untouch Flag
20 ASCII/Stream/No Untouch Flag
21 ASCII/Stream/Untouch Flag
06 Binary/Single-Point/No Untouch Flag
07 Binary/Single-Point/Untouch Flag
26 Binary/Stream/No Untouch Flag
27 Binary/Stream/Untouch Flag
All other mode values are reserved.
Mode 00 - ASCII/Single-Point/No Untouch Flag J2-Y, J4-Y, J10-Y, J11-Y
0,3